I'm re-doing my bathroom which has only the bare walls at the moment.
Its not a very big bathroom - 4 sq m. Previously it did not have any
electrics apart from the ceiling light. I am putting in an extractor
fan - off the lighting circuit. I'm also putting in a thermostatic
shower and underfloor heating. Both of these are to be wired to a new
circuit in the CU.
My question is regarding the location of the FCU's. Now if I were to
be a good sparkie then I'd put 3 FCU's for the above. Question is
where do I put them?! On the wall outside the bathroom I've got the
light switch for the bathroom next which is to the control switch for the
underfloor heating. If I were to put 2/3 FCU's near them it would look
a mess. I dont want this wall, which is in the landing, to look like
the distribution point for the national grid. Any ideas?
Regards
Tipu
Its not a very big bathroom - 4 sq m. Previously it did not have any
electrics apart from the ceiling light. I am putting in an extractor
fan - off the lighting circuit. I'm also putting in a thermostatic
shower and underfloor heating. Both of these are to be wired to a new
circuit in the CU.
My question is regarding the location of the FCU's. Now if I were to
be a good sparkie then I'd put 3 FCU's for the above. Question is
where do I put them?! On the wall outside the bathroom I've got the
light switch for the bathroom next which is to the control switch for the
underfloor heating. If I were to put 2/3 FCU's near them it would look
a mess. I dont want this wall, which is in the landing, to look like
the distribution point for the national grid. Any ideas?
Regards
Tipu