just wanted to know the best way to fit the base plate for a floor standing bath tap. Large brass plate with male 1/2" threads out the sides (with not much room for fittings to fit under decorative cover). As this is designed to be screwed down to the floor should i just use 15mm-1/2 bent tap connectors.
Floor is to be tiled, so no access once jobs done.
TC SERIES 9
http://www.tc-bathrooms.com/c/7317-serie-nine/54305-serie-9-floor-standing-bath---shower-mixer/
AND I have just noticed that they require 1bar, was going to run them of upstairs tank/cylinder but don't think thats enough
Floor is to be tiled, so no access once jobs done.
TC SERIES 9
http://www.tc-bathrooms.com/c/7317-serie-nine/54305-serie-9-floor-standing-bath---shower-mixer/
AND I have just noticed that they require 1bar, was going to run them of upstairs tank/cylinder but don't think thats enough