Hello.
I`ve been reading through the forum and can`t seem to find this one.
Problem is I have a vokera Linea 28, about 4 years old and runs on gas.
There was a leak underneath on saturday where the overflow that goes outside goes into the boiler so I tightened up the brass bolt on the end of the copper pipe and thought job done.
When I did that I noticed the pressure was low but the boiler wasn`t giving an error until I ran the hot water, then I get errorcode 4.
I turned the black valve underneath 180 degrees to raise the pressure to 1.5 bar but noticed that it wasn`t going up as fast as it would normally do so I thought that maybe there was pressure lost with the leak.
Now the pressure doesn`t hold at all but the boiler doesn`t give an error with the CH on till I run the hot water and I have to re-pressure it with the valve underneath. I`ve also noticed that water is coming from the overflow outside when I increase the pressure.
Do you think this will be a big job or could I do it myself?
I have all the servicing manuals and instructions for the boiler.
Any help is much appreciated.
Thanks in advance
I`ve been reading through the forum and can`t seem to find this one.
Problem is I have a vokera Linea 28, about 4 years old and runs on gas.
There was a leak underneath on saturday where the overflow that goes outside goes into the boiler so I tightened up the brass bolt on the end of the copper pipe and thought job done.
When I did that I noticed the pressure was low but the boiler wasn`t giving an error until I ran the hot water, then I get errorcode 4.
I turned the black valve underneath 180 degrees to raise the pressure to 1.5 bar but noticed that it wasn`t going up as fast as it would normally do so I thought that maybe there was pressure lost with the leak.
Now the pressure doesn`t hold at all but the boiler doesn`t give an error with the CH on till I run the hot water and I have to re-pressure it with the valve underneath. I`ve also noticed that water is coming from the overflow outside when I increase the pressure.
Do you think this will be a big job or could I do it myself?
I have all the servicing manuals and instructions for the boiler.
Any help is much appreciated.
Thanks in advance