Bend Radius and clipping distance

Joined
2 Jun 2008
Messages
48
Reaction score
0
Location
Lancashire
Country
United Kingdom
Hi,
Is the bend rad for 2.5mm T & E 29mm?
Also, I am routing the above parrallel with a floor joist so i intend clipping to it, length will be approx 2 metres, is every 250mm adequate?

Thanks for you replies.
 
Sponsored Links
Better to be safe than sorry: So clip that cable every 10mm of that tremendous 2M length. Try not to bend that 2.5mm cable, otherwise it might snap and go BANG!.......


Lucia.
 
minimum inside radius bend of 2.5mm T&E is 29.1mm
maximum(edit) clipping distance of 2.5mm T&E is 250mm on the horizontal and 400mm on the vertical.
 
Sponsored Links
Hammers handle length was taught at BT, and that tends to be a very good rule of thumb.

Someone would have to be rathaer 4nal to inspect a job and pull you up for being a few centimeters over the 25 cm rule.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top