Hi all
I have an immersion heater which has never worked, I’m guessing due to a broken element as there is power to the switch on the wall (led lights up) but the water never gets hot unless the boiler is on.
I’ve removed the cap but nowhere on the element does it say what size it is!
The cylinder has a label that says ‘Indirect Cylinder 36 x 18’, and the element goes into the top.
Sorry if this is a stupid question, but is a 27inch Heating element ok for this? Like this one:
https://www.screwfix.com/p/tesla-titanium-immersion-heater-element-27/75262
Ideally I want to get all the bits before removing the old one so I can do the job in one go.
Thanks
Andy
I have an immersion heater which has never worked, I’m guessing due to a broken element as there is power to the switch on the wall (led lights up) but the water never gets hot unless the boiler is on.
I’ve removed the cap but nowhere on the element does it say what size it is!
The cylinder has a label that says ‘Indirect Cylinder 36 x 18’, and the element goes into the top.
Sorry if this is a stupid question, but is a 27inch Heating element ok for this? Like this one:
https://www.screwfix.com/p/tesla-titanium-immersion-heater-element-27/75262
Ideally I want to get all the bits before removing the old one so I can do the job in one go.
Thanks
Andy