Recent content by 10phil79

  1. 1

    Washing Machine in Zone 2?

    Yes - Existing board has RCD - thanks
  2. 1

    Washing Machine in Zone 2?

    Hi - would appreciate your advice. Is it permitted to install the washing machine/dryer in a cupboard within a shower room. I appreciate this has been asked before but I cannot find quite the same scenario or a recent reply. The washer/dryer would be in zone 2 with the exception that it’ll be...
  3. 7CF79A91-1674-4B4F-A2B9-A3CBED8C8490

    7CF79A91-1674-4B4F-A2B9-A3CBED8C8490

    Shower room layout
  4. Shower room

    Shower room

  5. 1

    Installing Mira flight low profile shower ready

    Hi - after some advice on a new shower tray i want to fit a Mira flight square tray. The instructions say bed on 5:1 cement bed - which is fine. it’s to be installed on ground floor, concrete but I’ll need to rise it up to install waste. I also need to run a waste pipe under the tray to pick...
  6. 1

    1960s bungalow concrete floor

    Hi - i have a bungalow with concrete floor. In one room, the floor has sunken and looks like it on a old issue and hasn't changed in the last 10 years. the floor has sunken around 30mm evenly across the whole room, except for around the perimeter walls, where the floor rises to meet the...
  7. 1

    Mines

    We recently bought a house in an area with mining history. Around 5 doors up there is a vent-shaft under a drive and some gardens opposite have vent shafts also. On ground near by, four shop stood for around 25 years until one begun slipping into a shaft. The coal board attempted to grout but...
  8. 1

    strength of shed walls

    Thanks for the reply, it makes sense. I may look into this roof design a little further. Thanks ^^ i will end up purchasing some materials new, probably the roof battens and cladding for the finish. I am looking for reclaimed OSB or ply sheets at present but these are not so easy to...
  9. 1

    strength of shed walls

    Hi - i am collecting materials for my new shed (about which I have posted before), but i am now looking for advice/reassurance on the design. basically, I intend to use basic interlocking tiles on a 45* pitched roof but I am un-sure whether the design will take the weight of the roof. the...
  10. 1

    50mm waste connection to stack

    Cheers! Thanks for the info
  11. 1

    50mm waste connection to stack

    Hi can anyone confirm whether the floplast Boss pipe fitting sp581 can accept a 50mm waste pipe with appropriate gasket? linky to the item on screwfix -- http://www.screwfix.com/p/black-boss-pipe-sp581/97309 Screwfix don't state that this can accept 50mm connection but I am sure i have...
  12. 1

    Shock from amp plug

    I was moving my stereo amplifier and needed to unplug it. It was unplugged for a few seconds after which I picked the plug from the floor with the prongs pointing into the palm of my of hand. It gave me a shock-much more than a static shock, left my arm tingling for a few minutes. How could...
  13. 1

    expansion joints

    Hi - question relating to my driveway. Just had drains repaired and extended. The contractor has left the surface below the finished level, using scalpings and wacked them down. It's more or less ready for me to lay the surfaces. At the top end of the drive, I will be putting a shed -...
  14. 1

    tile onto different backgrounds

    Hi - I am about to tile our new bathroom... there are three walls to tile, each a different background. I intend to tile around the bath area (with shower over). one wall is just plasterboarded, the second is plastered but not painted and the third is an old bedroom wall which has layers of...
  15. 1

    wood preservative - shed timbers

    Thanks both - I assume this is the sort of product you are referring to? http://www.wickes.co.uk/clear-wood-preserver-5l/invt/170761/ Ta![/url]
Back
Top