Recent content by a1ek

The information I have been given is by Bosch and Nef UK? And they had advised to ask the installer. It seems that judging by the somewhat crude comments I will not get any sensible responses and will do what I think is right. Last time I user this unprofessional forum.!!

Hi Guys If I have a counter top gas hob can the final connection be via a flexible gas hose , or does it have to be rigid copper piping? I've read that you can use a flexible hose so long as the heat from the hob does not get to 70 degreed C near the hose.

Thanks for the advise it seems that most agree it's fine to just floor up to the plinth

Hi Guys I have been getting mixed views on wether a combi boiler can handle having a shower and say the kitchen tap running at the same time? I used to have an old Vokera in a previous house and I did notice that if you ran two taps the pressure of water dropped but not drastically bad but...

The floor is pretty good, do you think I could get away with just sitting the units on the exisiting floor and then adjusting upwards with the legs? The only think I dont like about this is that it can proove difficult with pulling out washing machines etc.

Hi Guys Im about to fit an Ikea kitchen. I will be putting down some flooring afterwards maybe laminate or tiles as I haven't decided yet, but I want to to save some money on the flooring by only doing the part you see. The floor area under the units I was thinking of just using some plywood...

Hey guys I'll be tiling my 3 walls in my bathroom and have measured the midway point on the first wall so I have even cuts both sides. The question is what looks best when you go onto the next wall just following the tile around so that if there is a half cut on wall 1 the other half...

Thanks for the reply, yeah I've heard nothing but good reviews on Bal i just need to get it at a good price , what should you pay for a 20kg bag ? Also is Mapei a good alternative?

Hi guys My bathroom I'm tiling is about 3 m square. I've installed a walk in shower tray with tile backer boards on the walls in the shower area, and sealed and tanked all joints with the kit that came with the walk in shower base. For the wet area i have used uni bond fully flexible...