Recent content by ash1900

hello forum! i was wondering if any of you could share your experience/knowledge with me? I am in the stages of planning and designing my new shed/workshop. It will be one building split into two. (one side general garden storage, bikes, mower etc) and the other a workshop and store for my...

ahh i see. thats fair enough, i do remebr reading somthing about it on another forum. so if i was to lower the deck, which should be possible. would this be ok? or is there other problems? and also make to my question about the ledger board and damp proof membrane?...

ohh :( why is that?

hello forum, i am in the stages of planning the decking for my home. The location where the decking will be installed is in a boggy part of the lawn, when it rains this fills up with water. the decking will be raise by at least 50cm off the ground, as the lawn also slops in wards towards the...

This album contains pictures of the plans and also the work carried out.

yeah i understand that, but i am planing to also plug CCTV into the 681 so this is why i ask to use the RF1 to plug into the tv next to the sky box. because i don't think this would go though the scart... EDIT: sorry didnt see the last bit of your reply. ok thats fine. On the wireing diagram...

thankyou! :) that can be done easily. so the RF1 on the back of the sky box. can this then be pluged into the back of the TV to insert the 681 feeds into the normal TV. thanks again. edit: are these plates fine to use? http://www.tlc-direct.co.uk/Products/CX122M.html...

hello forum i was wondering wether it is necessary to have the sky downlink from the labgear box down to the sky box. this is how i plan to have my set up; DOWNSTAIRS: sky+, coming in from wall(standard sky installation) --> to TV though scart then using the return link from...

i just havent had the need for heat shrinking. but i will be purchaseing some decent kit soon.

no i havent tried and im nto going to. because i know this house isnt wired liek that. the cables are held onto the wall with nails. (the head of the nail resting on the cable) but it is sorted now :)