Recent content by axg20202

  1. A

    Texecom Elite - cant change countdown volume

    Never mind. Worked it out. For some unknown reason, making part arm silent also makes the entry countdown super quiet (but not silent!). Strange behaviour really as an instant part arm sounds exactly the same whether it is set to silent part arm or not - there is still an internal chirp to...
  2. A

    Texecom Elite - cant change countdown volume

    Hi all, If I part set my alarm (this is configured to silent part arm - it just chirps to confirm it is part armed), if I open an exit door, the countdown starts but it is very quiet, just a low volume repeated chirp from the keypad and internal sounder to confirm it is counting down. The...
  3. A

    Texecom Premier Elite 24 part arm issue

    OK, the system is working normally now. No idea how these issues just resolved overnight but arming full and part now work properly. Very strange.
  4. A

    Texecom Premier Elite 24 part arm issue

    Thanks for your help, much appreciated. Yes, I’m arming as you describe, but the arming appears to be instant. Part arm instant is not enabled in area options. However, in area arm suites, there are two suites listed, both are set as Timed exit, but have no areas assigned to them. Is this...
  5. A

    Texecom Premier Elite 24 part arm issue

    It must have armed as the alarm went off when I tried to set it. As I noted above, I am part setting by entering the user code and pressing the part arm button, where it asks me if I want to set part arm, and I press OK to set.
  6. A

    Texecom Premier Elite 24 part arm issue

    The internal door in question is programmed as below. To activate the part am I am pressing the 'at home' button after entering the user access code. The keypad then asks me if I wish to part arm [part name]? So I press Enter. The event log doesn't really give me anything to go on...
  7. A

    Texecom Premier Elite 24 part arm issue

    I just tried it from the keypad (with the internal door open) and the alarm went off. Log just says exit started and exit stopped, and doesn't even report that the alarm was triggered. EDIT - I just checked the View exit errors setting, it was unchecked. Also, the first time I tried it I...
  8. A

    Texecom Premier Elite 24 part arm issue

    Actually, I suspect that pressing and holding on this sensor in the app is manually omitting it, which the system should be doing automatically when I part arm. Problem not solved.
  9. A

    Texecom Premier Elite 24 part arm issue

    Yes, it is. To be honest I’ve not tried it from the keypad. Edit: thanks very much for the hint. I just disabled the monitoring of that sensor in the app and it now part arms without the error message.
  10. A

    Texecom Premier Elite 24 part arm issue

    Hi all. I have a fully working installation with programming access via SmartComm and Wintex. Everything is working fine, but the last remaining thing I can't get 100% right is the Bedtime/part arm. Whenever I try to do the part arm, I get a warning that the system is not ready (i.e. the system...
Back
Top