The original plasterboard had water penetration, hence the reason for replacing with aquapanel.
Never thought of tanking normal plasterboard!
I will read up on that for future reference.
Cheers GCOL :)
Hi all,
I am about to embark on re doing my shower cubicle which has a stud wall on one side. I am going to replace the existing plaster board with the waterproof stuff.
Do I need to skim the waterproof board prior to tiling or can I just tile straight onto it with waterproof adhesive ...
Hi all,
I am about to embark on re doing my shower cubicle which has a stud wall on one side. I am going to replace the existing plaster board with the waterproof stuff.
Do I need to skim the waterproof board prior to tiling or can I just tile straight onto it with waterproof adhesive? ...
My partner insists that I switch the television off when we go to bed and not leave it on "Standby" as she says it will use 80% of the electricity. However she still leaves the Washing machine switched on when it has finished.
I think that 80% consumption is a bit of an exaggeration for a...
Thanks for your reply ch427.
I put some Redex in the petrol last Saturday and it seems to be going Ok now. (Keeping my fingers crossed). Hopefully it was just a dirty injector.
The last time I added a STP additive which didn't seem to do anything.
:roll:
Hi all,
I have two small annoyances with my Astra.
:evil: Every so often I get a lack of power when starting to accelerate, almost like a misfire but only for a second (if that). It doesn't happen every time and only seems to happen when I am in low revs. The engine management light...
Hi I had this problem with a blocked drain, it turned out to be a build up of soap powder residue from the washing machine (as mentioned in another reply)I put on a pair of long rubber gloves :( and ended up cutting the residue that had built up in the U bend with a knife. A lot cheaper than a...
I have a small leak on the tail connection on the hot tap on my bath (a drip every two minutes or so) It is a pain to get access to, even with a basin wrench. I have tightened it up as much as I can with little success. I suspect that there is a rubber seal in the connection that may not be...