Recent content by BFG

Modified accordingly.

With respect, I simply asked for material sourcing advice, not a critique of what you assume my project is. BTW, I don't watch TV.

Hi, we have a groundwork project which is nearly complete. It's a paving area with grey millstone flags with uneven edges. To infill the joins we need to find a sand as would be used for block-paving of similar, or maybe even a fine gravel of 2-5mm. We've tried all our local suppliers and...

So when split loads came out first, when time served electricians asked for info leaflet - in the time between asking for it and when it arrived, did they become incompetent? I don't see why a request for the latest techincal information renders one incompetent. It is a very competent thing...

A little history. Boiler pilot light went out and wouldn't re-light. Plumber called by my partner, he told her it was condemnded and he wouldn't relight it. He'd fit a new one for us though. £2,000. Or £2700 if we wanted it in the loft. Can't do anything for 3 weeks though luv. So we...

And I take it that you are? So what are they then? By your own assertion you should know them off the top of your head, surely? Or would you need to look them up? Like I have to. :wink: :wink: You see, my original post mentioned I couldn't find them for free, That was my point...

Loft is boarded, there is a fixed ladder, fixed light, fixed banister. Vaillant has built in frost thermostat. Also, pipes will be boxed in with insulation, and there will be partition walls made around the boiler to enclose it. The boiler is a sealed-room type - all part of the plan. See...

I find that perspective frustrating. This is my third install with no problems. I just can;t find my copy of the regs.

I am installing a combi boiler in our loft, which will be commissioned by a Corgi-reg plumber when complete. The manual references adherence to regulations when sited in a timber framed building. It makes sense that this also applies to my loft. I understand these are primarily to do with...

I'm noting a lot of unwritten rules in this forum. Perhaps you can enlighten me?

Yes. I noted your objection, but it wasn't clear what should be done about it. I think I'm missing something here. Are we required to search before posting in "general"? :)

I would recommend shielded cable if it's going to run anywhere near power cables. :)

If they're not too deep you can polish them out. Over here we would use brasso metal polish. You can speed it up with an electric mop, but be careful not to go too far.

Try Cement powder. Failing that, there are many proprietary cleaners available from DIY stores.

The smell is caused by bacteria growing in the machine. Use of biological detergents makes this more likely to happen (the clue in in the name :wink: ). Also, more washes at lower temperatures such as 40deg makes this more likely to occur. As previously stated, maintenance washes + leaving...