Recent content by bigbeak07

Hi, which is the best method of doing this? Ply, heatmat, self levelling compound then lay the laminate on top of the compound? Advice appreciated

depends on your cold water flow rate, pointless spending the extra on the bigger boiler if your cold water flow rate is only 10litres per minute. If it was me id go for the 28kw ample for this size of house with one bathroom.

yes fitted collars and used there own plastic pipe and inserts. tho they did admit that there was problems with there fittings onto older copper but no warning on there packaging. will never use them again, on the other hand hep20 is superb!

have had repeated problems with the floplast fittings when connecting onto copper pipework all on the same job. the fittings seem to be pulling off the pipe, not all the way, but enough to cause a constant drip. plastic to plastic seem fine, after the 4th leak i ran floplast to complain as i...

Hi has anyone on here having problems/ issues with these fittings leaking etc, have spoke to floplast and they have admitted a problem with the product. anyone else any past experiences that they can share. I have now learn't to never buy cheap c**P again! :oops:

glow worm flexicom is the only one i can think of, rear entry flue, still awkward as hell to pipe up in a small space tho.....

hi,just wondering if anyone knows where i can get a loft ladder and hatch with will have at least a minumim reach of 3.1metres. the only ones i can find are a maximum of 2.8metres. Your help would be much appreciated. Thanks Nathan Saville

bosch kgn34x00gb/01 fridge freezer. frost free type. freezer working ok fridge warm. have defrosted for 8 hrs now. stripped air vents but unable to remove cover from radiator area at top of freezer. how do i remove this? all screws have been removed but not budging, i do not want to force it for...

if u don't have the valves open maually when refilling the system it creates airlocks. opening the valves manually then running the system clears these airlocks! :D

plumbfix only seem to sell floplast and speedfit. not keen on these fittings. any one else know of any websites selling h2o (hep) or polyplumb?

just an airlock mate, turn both zone valves to manual then switch system on. leave running for a little while to clear air. after that switch system off close valves to auto setting then try again. :o

thanks bud i'll have a look! :D

my advise would be check that the pump has been fitted the right way. usually an arrow on the pump for direction of flow. the arrow should be pointing towards the 3 way valve. another thing would be to reduce pump speed. usually 3 speed levels with these pumps try the lowest setting first. the...

:roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: been there got the tee-shirt with this problem!!

was your system flushed as per manufacturer's instructions when the new boiler was fitted? :roll: