Recent content by bingbonglong

OK, thank you. Do you know what the front left connector is for??

OK, I'll do that later this evening. Thanks.

Thanks for your reply. I should have been clearer: it's not so much a multi-terminal as two completely separate terminals, one on the front left of the motor and one on the front right. I see the schematic in the doc you attached, but it only shows two connections on the motor (whereas in...

Hello, I have a Triton AS2000XT shower. It developed a leak, which I think I've fixed but I stupidly didn't take a picture of the wiring connections to the pump/motor unit before I took the thing apart. I know the blue wire was connected at the back of the pump/motor and the brown at the...

I've now replaced the solenoid and the valve (in one go). I'm sad to say that the problem is as bad as it was before. Can anything else cause this? When the water stops, the motor spins much faster (higher pitch noise). This is really starting to annoy me now! :x

It turns out that air is blowing out of the bath plughole, not being sucked in through it when I flush the toilet. I've proved this by removing the AAV and replcing it with a sheet of clingfilm, which balloons up when I flush. This explains why the AAV is not opening, but why is air blowing when...

buck51, thanks for your reply. How would I reconfigure the plumbing? What needs to be where in relation to what? The basin and bath are combined into one pipe before they reach the soil stack. I can't see how this was done without removing tiling. The toilet empties into the soil stack about...

My soil stack terminates in my upstairs bathroom. The toilet, bath and basin all drain into it about 1m below the top of the stack. I have fitted a Floplast AV110 air admittance valve on top of the stack to ensure that there are no smells escaping into the house. The problem is it doesn’t seem...

Thanks again but I don't understand. The shower has to be on for the fault to occur.

Thanks for the reply. I've just measured it at 3.5kohm with the shower switched off. Hard to measure with shower switched on :(

Thanks for your reply Onetap, but there is no mention of any of these items in the manual I have.

I have a Candy CDB126 washer dryer. Quite often when I select "spin", it starts a wash cycle. Has anyone had this problem? How did you fix it? Many thanks.

I have a Triton AS2000XT electric shower. It is basically a glorified mixer/pump and does NOT heat the water. Quite often the pump starts but no water comes out. Or the water comes out for a while then dies away. Has anyone had a similar problem? What did you do to fix it? Many thanks!

Hello, did you ever solve this problem? I have similar issues and would love to sort them out!

Hello, did you ever solve your issue with the Triton power shower? I have similar problems (although intermittent) and would love to sort it out! Thank!