Recent content by Bobajob123

do you have to be gas registered to change a safety valve off the boiler

no work done.... i turned off all the rads bar 1 and its hot at the bottom but not at the top....

1 bar on the system... tried bleeding the system... no air in the system... most of my rads are piping hot at the bottom but not at the top... anyone know the problem

potterton prima c boiler sealed system.... i bleed the pump there.. water dripped out... spinned the pump...

as above... i felt the pump and its roasting hot... is the hot water not flowing thru the pump or somethin

Just installed a water tank in attic.. the old tank had its day.. when the tank is just about full it start to make a really loud shaking noise.. probaly the ball valve and the water... how can i correct this problem

really... il ring... think it mite be time for scrap yard

have a problem with me car 99 mitsubishi colt... the steering linkage rack and pinion is worn... is this dear to fix

Its a monobloc tap... The hot is grand.. but the cold has being kinda weak pressure and now theres nothing at all.... all upstairs of the tank is grand.. just at the kitchen cold... any ideas

All rads downstairs grand..All grand on 1st floor bar 1... its hot on bottom,tried to vent it but no air or water comes out... and the 1 rad in the attic is stone cold... whats the problem???

Its fed by tank in attic mate.... what will i use to block the cold water outlet in tank

Tightened the wing nuts to the max... but my toilet is still leaking... its a close coupeled toilet with a flush button.... it seems to be coming from where the donut is situated.... there is no valve to stop the toilet filling up... whats best way so i can take off the cistern

This is the floor.... so im going to put down the ply 12mm wbp.... then screw it down with countersinking screws every 150mm.... then use acrylic primer on the ply.... is that correct.... have a mate thats doing the tiling... just want to get everything ready

Sorry my info wasnt that clear... took up old timber on floor... going to put plywood down and then put the tiles on... screw down the plywood and put down acryic primer on ply... anything else im missing.... sumone said to me about a water sealant but only a toilet and sink going down

Going to tile me bathroom... do ya need to put plywood down to tile?? the floor would be to high if i done that and whats a good water sealant for under the tiles