gents
RA - Knuckle bend
water not draining away at all or very very very very slowly -.......
trap removed and tried over a sink and OK!
think there seems to be a 'dip' in the pipe somewher and it its acting like a 2nd trap?????
if i blow down the pipe i get 'resistance' like i...
new marley low level trap on an elevated shower base. RA bend after 6" and a vertical drop to a RA bend then slow drop to 45 bend to t piece to main.
why will water not go away?
well it is blu has two arms .......
weighs about two tons..
has lots of pockets.....
:idea:
stay away from fires and we wont need one
but jointers use gas.... and flames.....
would not be without me orange insulation....
but then again the 5Kv gloves are good as well......
and the rubber boots
flame retardent overalls
nomex jacket
hard hat with built in face guard.
J
cast iron cable heads notorious for this . remember that the main cable may also need to be changed as there is a restriction on removing CI cable heads live. - Do you also need the 3 phase supply?maybe better to get rid of it and renew the sevive wit a 25mm split - this will give you all you...
Once again my extreme apologies to the listeners on this site - Can someone please look thro the offending posts and tell me where I ever asked Mr joseph with the 90 glasses for assistance or indeed have taken said advice?
Mr Joe did not - and I emphatically repeat -- DID NOT -- tell me give...
it seems that there must be an answer - in direct conflict to my previous statement regarding vis a vis the non answering mode in respect of the posting to this particular thread.
Thank you Joe.
:wink:
naccos is irrelevant and lorraine - the wee wifie says you are a clown for the way you are going on.
who is joe by the way.
I rcvd an e mail from a company domain ie weejimmy@big co .com
not anyone called joe.
as for me being an "chief b###s#####r" I am sure there is a liablest...
seems that this is a contreversial topic and maybes we need an explanation ....
the wee wifie sleeps better at night when the wee alarm boax thingy is switched on!
every aspect of the system that is required has been tested switched on omited part set by an engineer with the correct...
sorry gents i seem to have caused a bluster.....
the alarm is operational in all its finest glory - thanks to the anonymous donor.. your kind thoughts and wel meant verse has been duly noted.
you were of course correct in your estimations of the saxon male whose incessent ramblings no...
having been told to ignore you
and subsequently reading you post to me
I can now understand why.
some one who knows what to do ? - Ok perhaps you are correct
after all My degree in engineering only allowed me to move from my tradesman job as a electrician - engineer - 20 years ago...
Gents
I have read thro every mail post on here regarding these alarms and have come to the decision that I should rip it out and fit a 4 zone optima!
But
Its not mine and I have to try something .....
I managed to get it reset thanks to a post earlier last year. NVM reset.
Now I...