Your system is pumping over, this is most liekly to be caused by a blockage. Most probably where the feed pipe from the tank meets the system.
Get a plumber round asap to remove the blockage then you will be fine
1. You will need to drill a 4" hole through the external wall for the waste pipe. Cut into your soil stack outside and run the new waste from the stack to the new hole. Extend the waste through the hole. The waste will probably need cutting back when fitting the toilet. Make the toilet up, there...
The wee one is your F&E tank. This is used to fill and top up your heating. You can either tie the ball valve up or turn off the supply by means of a stopcock. There maybe one in the loft otherwise the main one as it enters your home. Once this is done you can drain the system. Attach a hose to...
have to agree, small diameter sytems are a nightmare sometimes. If re piping is an option run as much as you can with 22mm and the rad runs in 15mm. As a rule of thumb only pipe three rads at maximum off a single 15mm flow and return loop
Can anybody shed any light if this model has an fsd incorporated into the gas tap assembly. No literature available only a parts list.
Any help will be appreiciated
there must be a point of isolation on this flexi or something just before or after. Otherwise the system would just keep filling and eventually start coming out of the safety discharge outside
I am thinking of putting a new kitchen in. This will be in a different place to the existing one. The only problem I can foresee is the waste. There is an inspection chamber outside where the new kitchen is to be installed. I can dig a pathway to the chamber, but not sure how to connect the...
Seems a little high, the water expands as it gets hot thus increasing pressure. The prv on the boiler is set to 3 bar so as long as this is not opening you are fine