*******s. Any other suggestions for a potential work around? Only thing I can think of is remote disarming the house via the HC app before going through the front door (when C is set).
Would the front door still alarm if set in Night Mode though? Or would it start an entry timer?
Basically I'm after: A or C - start entry timer. B - Alarm
I'd have to check when I'm home and report back.
Does the area set alter the input type? I assumed that because the entry timer is started on the front when A is set, it should also start when C is set. Obviously not the case atm.
Hi all,
I'm after some help with regards to recent changes I made to the enforcer system.
For reference I have had this installed for over 2 years without issues using full set/night set daily.
I recently added area C to the mix, arming everything as per A with the exception of a garage door...
Haha nice diagram SFK!
Thanks for the info, think I got confused with 2 physical wires rather than a pair of wires within a wire. I guess as long as they are linked together with a resistor one end and a multi-meter the other end it should make a circuit.
Cheers
Cheers SFK
I have some chock-blocks and can borrow a multi-meter from a friend for testing. The bell box actually came with a resistor in the packaging so I'll see if I can find the ohms of this to see if it can be used.
Just to confirm, there was only 1 wire on the outside of the wall...
Hi all,
I recently installed the Pryonix enforcer V10 with the WE bell but the quite disappointing LEDs on it have left me wanting more of a visual deterrent so I am thinking about replacing with the deltabell plus or X (with lightbox) module as I think from research the housing and cover are...
Will take note re. the sensors.
Yes walk test was fine, I figured out what I did wrong last night after completing a clean start and just adding one PIR so hopefully the below helps someone else if they have a moment of denseness like I did.
For all PIRs/contacts, I had set the input area as...
Im in the process of installing the Enforcer V10.
Everything is done apart from the bellbox, before I connected it I wanted to test the system alarms when it should and that the sensors are set up correctly. But I cannot get the alarm to trigger!
When I set A the exit timer is started, I open...
@sparkymarka any ideas why the alarm is not triggering?
When I set A the exit timer is started, I open and close the front door, panel makes a chime noise but then when I reopen the door the entry timer is not started and waving in front of the lounge or kitchen PIRs does not trigger the alarm...
Not sure why the alarm isn't sounding then. Like I say I get the exit timer when setting A, quickly open and close the front door then run back to under stairs cupboard (out of view of all PIRs), system bleeps but nothing is set.
Thanks sparkymarka!
Wasn't able to test last night after making the changes as the alarm would not set after entering a PIN and selecting an area. The countdown starts, it bleeps but alarm is not set. I guess this could be caused by the bellbox not being learnt to the enforcer yet (run out of...