Recent content by d94ccm

Ok guy, The system is fixed! i managed to sort it our about an hour ago. I would like to say thanks to all of those here who helped me out. Funnily enough this is what was wrong. When I turned both of the taps to re pressurise the boiler the one on the right did not turn with the...

Any particular reason why I may have low water pressure? It sounds weird as it was working for the first 4/5 months of me living here.

Ok, That seems to explain quite a bit! :) Thanks

If this is the case what's my next plan of action?

Ok i'll wait until tonight then try again! If the reader is faulty that would mean however that the water should still be hot?

Thanks for the manual, I have opened both taps: Nothing happened. I have opened both taps + pressed reset: Started to make some noise, pressure went up to 0.6 then stopped and dropped back to 0.5 I did this again and also turned on the heating. The central heating temp started to...

Thanks, Will get a chisel and give that a go! Yes sorry not poly filla! I'm a bit new to all this.

Ok have opened both taps and nothing, do I need to press reset? Sorry if these are dumb Questions. Email is [email protected] Thanks

I do have the users guide but not sure it is the main manual, It says nothing about how to re pressurise. Will give it a go though! Thanks

Hi, I think i may have a leak under my bath as the ceiling in my kitchen has some damp patches. I painted over them with whit paint and filled in the area around the edge of my bath/shower with poly filler where I thought the water was seeping through. I'm not 100% as the damp could still be...

Hi, I'm a newbie to DIY and particular boilers. I have a Glow worm Flexicom 24cx. When i first moved in to the house it all worked fine and had plenty of hot water. However not the hot water is not so forthcoming. The pressure constantly says 0.4 bar and begins to flash just after the hot...