Recent content by David Foster

A big thanks again to you two for your help. All sorted, working great, cheers.

As far as I know, no. No HW cylinder or tank anywhere. The display on the controller has a tap on it! Do you think they have just used a controller that they had in store? The houses were built in 2018, when we moved in 2 years ago, the previous owners never left a single bit of paper on how...

Thank you both for sharing your knowledge, much appreciated. I had installed a single hive in my previous house, but direct to the boiler, no wiring centre nest of wires or other zones. I understand what you mean about starting again stem :D but it is what it is. RandomGrinch, yes, about...

Hi, I currently have a 2 zone (upstairs/downstairs) central heating system with combi boiler. I use the controller set to RUN (don't use the programmer) and control the heating with the 2 wall thermostats. I want to replace the 2 wall thermostats with Hive Mini thermostats. I plan to remove the...

Ordered a Rangemaster, see how it goes, thanks.

I have to order installation with the order, they say guarantee etc it fits, this could be a nightmare. They only ask that the zones are okay and the top width.

Yes, I must have browsed every single one and the manufacturers sites as well. I have found a couple of 550mm ones but we are talking wife wanting a black glass one :rolleyes:

Hi, I need to order a new gas hob in a granite worktop. The width of the granite cut out is 557mm and the bump on the underside of the old Belling hob is 550mm. Almost all of the new hobs state a cut out of 560mm wide. What is the size of the underside bump in these hobs asking for a 560mm hole...

Thanks, iPhone SE, the little one. They chamfered the frame in the end so they sit better, but yes, mastic, trim and expanding foam! Went off site in afternoon, something urgent, so not all glass in yet.

Hi, Fitters have gone home, they are due back tomorrow to fit the glass. Looking at it, a few dubious things. I would be grateful if someone could help and confirm my fears please with the rafters to roof. At Point 1 rafter is 20mm above frame and at Point 2 it is touching frame leaving a...