Recent content by dazzlerpalmer

Cr*p idea?

Hi I am thinking of creating an airing cupboard across the other side of the house. We have a standard gas boiler. I am planning on picking up on the feed and return hot water pipes and routing up into the loft across the house, down into the cupboard and back and connect to the return...

Hi I have a cooker hood that sits between two wall cabinets. These wall cabinets don't touch the hood (there is a bout a 2 inch gap either side) Do I tile up to the bottom of the hood (either side of the cabinets) or what? I could tile up to the bottom of the units to the top of...

Thanks for that. I stuck a piece of wood next to the splashback and after12 hours I just peeled it off easy. I did it again and left it 24 hours and then is stuck fast. I was just too impatient - it seems to be okay. cheers

Hi I have recently bought a black glass splashback and was advised to stick it to the wall using non-acetone silicone. I bought some water based silicone (black) and applied it all over the back and on the wall. I supported the splashback with a baton and left it overnight. The walls...

That will do it thanks I have order a rectangular 150mm vent kit with some extra 90 degree elbows. I can then extract it 18 inches lower. I will probably lose a little effeciency but not that much. The overall run is still less than 3 metres.

Cooking? I just eat the stuff. I wouldn't know the hot part of a saucepan! Trouble is the awning cost loads and I would not want to ruin it. I could vent to the side of the house but this is a 4 metre run and it comes out right on the flashing of the flat roof.

Hi I need to install a cooker and and I want to extract it outside. The problem is that the closest external wall would mean that the exit point would be directly under an awning (about 2 foot under). This is putting me off. I can't lower or higher the exit point easily. How much...

Sod it ! I am going to get a roofer in.

My english leaves a lot to be desired. I meant how do I fix the ply to the plastic UPVC top of the bay. I think the lead then just lays on the ply. I may clip the lead into the brickwork though At the moment it i not leaking but I know it is only a matter of time. The bay is 3 meters wide...

Hi I am planning on capping my plastic bay window with Code 4 Lead. Am I right in thinking I need to mount the lead on 18mm ply. If so how will I stick the ply and then the lead? Thanks p.s. any other tips on this job will help Thanks Again :shock:

Gentlefolk I want to redo my flat roof (over a utility room). The trouble is I am in a quandry as to what to go for. There seems to be so many flat roof companies out there. The size of the utility room is 16'x8'. I am inclined to get a builder to convert this to a pitched room...

Gentle people Last night my dad's AAV (in the loft) on the heating system broke and started leaking. We managed to get to it before the ceiling came down luckily. Can we replace the AAV (auto valves) with manual valves to stop this happening again? The system is run by a Concord WCF...

I am going to put it on a fused RCD protected 4mm cable I think. I am also dubious about cable outside - any recommendations?

We had this when we bought our new house. We were convinced it was the previous owner - hiding a kipper under the floorboards. It turned out to be the plastice light fitting.