Recent content by dmjones500

Our new house has a fully boarded loft with insulation laid over the boards. We’d like to store things up there without compressing the insulation. I’ve seen loft legs are a common solution if you’ve got joists under the insulation. Given we have boards underneath, are there any other options...

Thanks, I guess I'll give it a few days and see how it goes. Magnetic filter sounds like a good idea - I'll see if I can find somewhere accessible to fit it onto the system...

I've now cleared the blockage. It was in the lower tee (circled in my first picture). I decided against dropping out the pump, as I was a little unsure about fitting it back again without leaks. So I cut the pipe below the top tee and had a nosey with a screwdriver. That was all clear, so I cut...

I was planning to cut the pipe just below the 15/22mm tee (my second picture). Is that ok?

Thanks folks. So I will cut below the 15mm/22mm tee, allowing me to clear up and down the 22m pipe. If that isn't where the problem is, I'll cut the 15mm and tackle the problem from there. Stupid question, but can I use a push fit coupling to join a pipe I've sliced? Would I be able to force...

The cold feed enters via a tee, slightly higher up. There is no magnetic material that I can detect at that joint. Photo below (15mm pipe is the feed coming from the f&e, 22mm is the vent. Is there any way to figure out if the blockage is there without cutting?

OK, good. Yes, I've drained it already in the manner you suggest. Thanks for your help, I'll give the pipe cutting a go...

What I've done so far is to drain the heating system, opened all the rad valves and also the air valve you can see in the top-left of my picture. I'll either mop out or bung the f&e tank before I do anything. Is there anything else I can do to drain things before I begin? I'm assuming there's a...

Thanks for the reply. Just to check I understand, am I cutting the pipe once above the tee? If so, do I just bend it a bit to get access with the screwdriver? Also, does "drop the pump out" mean to unscrew it from the tee? Or do I unscrew the pump at both ends and get it out the way? And...

Hi, Today I drained my open vented heating system to change a leaking radiator valve. The system appears to have fully drained - all radiator valves are opened upstairs and downstairs, and the draining water has stopped. The header tank is still full. Research suggests this means my cold feed...

Brilliant, thanks! I knew there must be a simple answer, not sure why I didn't spot those already!

I need to replace a broken fill valve, but I can't access the nuts at the rear of the toilet. A flexible hose disappears inside a relatively small hole and I can just see the nut if I shove a camera under there: Looking in the top of the toilet, there's nothing that suggests I should...

But surely the same is true for main roof guttering, yet we feel the need to drain that correctly? Do I really not have to worry about this smaller volume of water?

Hi, Our conservatory guttering is connected via a downpipe to a water butt. Currently, if this overflows it simply spills out onto the concrete outside our conservatory and kitchen. There is no drain outside this part of the house. All the downpipes on our main roof guttering go into our...

Ok, the filler seemed to be sufficient. Thanks for your help, will bear in mind in future. I guess I normally gloss over caulk (e.g. Skirting) so hadn't come across this before.