Ok Guys
The heating was playing up the other day, so had the pump changed by a plumber.
Then we noticed that the heating would only cut in once the hot water was called for(i.e. tonight no central heating, ran hot water for a while and boiler and pump cuts in and heating comes on!!!!).
I have...
I have a salamander CT 75 Shower pump.
Cold tank in the loft hot tank in airing cupboard pump sits on top of hot tank.
The pump works intermittently from start, switch it off an on a couple of times it will work.
After a couple of mins the shower stops, lower the shower head (type on a...
Thank you for your reply, but what I want to know is do I start laying a the long wall and finish at the small door area or start at the small door area and finish at the long wall.
I have a bedroom that is 2.4m x 4.6m and the door entrance is is an area to the side of the long length of 1.2m x 0.6m (so L shaped)
I want to lay a laminate floor where should I start the long length or the small door area??
I have layed floors before in 5 other rooms but they were all...
I have 2 showers one with a large head and one a normal head the flow to the large head is very poor. i have a gravity feed vented cylinder.
it has been sugested i either use a twin pump or change to an unvented cylinder.
i have been quoted £500 pounds to supply and fit a salamander pump...
smeg dish washer E1 & E2 code tried reset, switch on 4 presses of program button, switch of for 20 seconds still has E1 or E2 Code, machine fills heats up then stops with same problem reset again and then pump just keeps cutting in and out at about 1 second intervals empties water from machine...
Boiler fails to start after short time of no demand. have to mess about switching boiler on and off changing over pump speeds and then then boiler starts. but comes up with -ll- and boiler flow temp. Book says trap filling is in progess but should only happen after long periods of in activity.
Ok changed midpoint valve to diverter valve problem still exists with cold water tank heating up. NRVs in pipes to shower mixer tap, sink mixer has isolation valves. If i turn off the boiler and pump and use immersion heater to warm water and hot water does not back up to the cold water tank...