Recent content by ferkh10

Door is sticking at the bottom and need to adjust it. The hinge has two Allen key screws at top and bottom and a small grub screw in the middle. Which screw does what?

Cheers, I could replace the whole unit with the above. The actual units are not under boards, the boards are through the middle of the loft and the units are at the side (not under boards). Would replacing all of the units solve the flickering problem though?

Here’s the LEDs I bought. https://www.toolstation.com/integral-led-12v-mr16-gu53-lamp/p35057 Cables are under boards will loads of stuff to be moved to get them up, bit of a pita to trace

Sorry, been busy for a few days. Here’s what’s inside that white box. It is an old PC PSU, it’s in the loft just stored with other PC bits - nothing to do with the lighting Could well be an old wired house alarm (decommissioned) in the mix also. As above, will rewire with GU10 fittings. Assume...

Now I’m more confused. Just fitted an LED transformer to that last bulb and now it doesn’t work at all. Do all of the bulbs in the circuit need to have a transformer fitted?

It’s not a faulty bulb, I’ve swapped it over for another one and same happens. There’s 9 bulbs in total, 3 rows of 3. If I put 8 bulbs in and leave the last one as halogen then it’s all fine. As soon as I swap that last one for LED then it starts to flicker. Just tried to swap the last one...

I want to change a set of Halogen bulbs in my bathroom to LEDs. I've simply replaced the bulbs but the last one flickers (all of the others are fine). Been told I need an LED transformer. I have these 2 boxes (one black, one white) in the loft where the lighting cable goes into, then out of...

If I took a 15mm feed off the existing rad would that work, or does the whole system need to be changed to 15mm?

It's 8mm, will try closing lockshield. Assume 15mm pipe would work?

Heres the other side of the wall

Here you go, it's hooked up to an existing rad on the other side of the wall. Flow out of the existing rad goes to flow in on the new one (although I don't believe it matters hugely if hooked up backwards)

Added a new radiator to the system but its not heating up. Have bled the radiator, all fine. Pipes are hooked up to the correct flow. No leaks in valves, pipes or radiator. Pressure is fine on the boiler. Hot water & hot rads everywhere else. Valves are fully turned to on position (duh!) Taken...

Connected those back up. Looks like fuse has blown. Need to find a 3a fuse now!!

Yes, power is now off. The wire that’s still connected goes into the boiler. The one that’s one out goes to a fuse box

Accidentally pulled a cable out of my Hive central heating hub. As can be seen bottom right. Does it just go back in with the existing wires, or do they go into separate connectors?