Recent content by gboy

Hi all' I've bought a compressor for my Bosch fridge/freezer model kvg33nw20g as it was too good to scrap! But I need someone to come round and install it for me. I'm in NW1 if anyone's available let me know before I start phoning around!

Hi thanks for the replies, yes it's g-force by tetrosyl and ep and hypoid. The guy behind the counter reccommended mineral 80- 90 and tetrosyl said afterwards that only ep 80 could be reccommended. I've previously used fully synthetic in an old 405 peugeot g/box without probs though! Thanks...

Oops forgot to mention it's a 2.3 diesel on 213k miles.

Hi I've just changed the oil in the van gearbox. It's a 208d pre-sprinter. Specified oil is sae 80. I decided to use fully synthetic 75-90 but have since been advised that this is wrong. Any advice much appreciated!

Hi thanks for that. Do you think the radiator circuit should be flushed as well? I'm almost certain this was not done when the boiler was installed six years ago as a replacement for approx 22 year old Ideal Sprint!

Last time boiler was serviced the engineer said it was refusing to power up properly on central heating. it's a HRE 28/24 intergas model. It fires up ok but immediately powers down to about 20% which results in radiators not getting very warm. The engineer said it could be the pump or the pcb at...

mercedes 190d 2.5 now there's a good design.......

hi john thanks yes that was my plan as stated. Was just wondering if there should be a live showing at the abs control unit fuse or is that normally "killed" once the light is on?

hi abs light on on 94 1900td 405 exec. i,ve cleaned uo sensors and front crusty rings. rears were clean because they're inside drums. next i'm planning to test if there is mV output from sensors and ohms across sensors. abs control unit fuse is ok but i noticed there isn't a live at the fuse...

Bit of a long-shot but I was wondering if anybody had a modureg solenoid knocking around that they could sell me (honeywell v7335a 2026) for my poor old ideal sprint boiler!!! I believe the worcester also uses a similar part.

It's a pug 1.5 diesel. Thanks for the other replies too. Noisy in neutral when not moving i.e input side of gearbox driven by engine. Clutch down dissconnects the box so it was quiet. On the move however gearbox is rotating from it's connection to the wheels even if the clutch is...

Any transmission experts out there? I've got a loudish whine especially so in 1st, quieter though still noticable in 2nd gets quieter again as you go up the gears. Still there if I push the clutch clutch down but disappears in neutral. Should I change the oil then change the box if new oil...

Hey mattylad, thanks for trying I'll continue the search :roll:

Hi mattylad, the place where manufacture date would normally be displayed just says "manufactured:" but must be missing a stick on date. The receiver was purchased in Aug 2002 however so I'd guess it was made sometime around 2001/2002 .

Hi it's a model HCD-EP303, there is a serial number, I'll just go and check. It's 6136606. Thanks.