Recent content by gorty

I installed a bit of connector block as a final fix, everything running fine now for past few months, many thanks. On a similar topic, I'd like to add a GSM switch so I can control the heating from my mobile. The GSM switches available have two relays, these can be switched by calling, or by...

many thanks. I have a ecotec624 system boiler, but it's still figure 4.17 and pins 4 and 10 on X2. I don't need the harness pictured, but I do need a 2way connector that mates with the 2way connector that's attached to X2. In the meantime I've jammed in the leads from the VR10 and secured...

did you find a solution, I've got the same problem, Vaillaint engineer also confused.

I realise this is an old thread, but figured anyone looking into this will be most likely to find this thread, also it continues on from the discussion above. With the view to buying them, I've been reading the installation instructions for the products VR10 with UniSTOR, Ecotec plus 624...

I realise this is an old thread.. How did you get on? I'm consdiering buying a VRC430, VR61 and VR81 to control a 2-zone heating and DHW install. It's a vaillant system boiler with UniSTOR unvented tank. Is the controller any good? easy to use? save you anything on bills ? The vaillant...

I've looked at the Viessmann Vitodens 200-W What is the advantage of mixing the UFH water locally at the boiler? I'm assuming it's only a small saving in efficiency as your not heating water to 90-ish-degrees to mix it down again at the UFH manifold. If I go for this boiler, am I tied to...

sounds like you have knowledge of the quality of cast iron rads? at what foundry are the mhs rads cast? and what is the exact spec of the paint? likewise, what's the comparative foundry and paint spec of the coventry offerings? it seems there's no manufacturing standards expressed by...

checkout the prices here: www.coventry-demolition.co.uk

thanks, usful guide, if only the scottush regs were to easy to navigate. I've got some phone numbers for the scottish government, hopefully they can point me to the equivalent guide, which is probably the same.

anyone up on the design regs ?

MHS, some of most expensive I've seen, and they're in Basildon.

I now of a salvage yard in Falkirk but I was looking at buying new radiators. I'm sure the clued up developers will buy them direct from turkey or similar.

can anyone point me to a diagram/guide of the design principles/current regs to be applied to the drainage for a new bathroom. The neighbour has already made the same modification in their house, their plans show AAVs and boxed in pipes to the corner of the room, seems like overkill. We're...

can anyone advise who/where in scotland can supply cast iron rads, and where could we view before we buy, I'm a bit hesitant about commiting to buying 3 rads online without seeing the quality of the castings

I've redrawn to make the pipework closer to reality. I'd added two rads I'm having in the garage, the back half of the garage is a sunroom/guestroom, the other rad in the garage is for occasional use when I'm out there faffing about. The reason for the underfloor is to provide an extra heat...