Recent content by johnnis

hi getting walk in bath fitted for mother 1 u sit in and then fills it in system is gravity fed and have been advised to get pump fitted to boost hot and cold supplies can anybody suggest make and model thanks

thanks heatingman wheres the best to fit air vents thanks

hi my indirect cylinder needs changed (due to leak at seam)pretty confident replaceing apart from new cylinder has 2 tappings for flow and return on side but old cylinder has 2 15mm pipes coming out the top of cylinder looks like where immersion might have been can i just cut the pipes below and...

hi fitting 8 new rads replaceing five with trv s will i have to fit a automatic bypass valve thanks

nee to move rad pipes in new house have one this before on a stanar heating system cap expansion and cold feed but new house has thermal store with f+E TANK ABOVE CAN I BUNG THIS TANK IN SAME WAY OR IS THERE AOTHER WAY thanks

REPLACE THE FLOW SWITCH STRAIGHTFORWARD JOB

no that now but was advertised as corgi

hi had engineer out today now no heating in 1 rad called guy to move i rad and change faulty 2 port valve on hot water did nt start too well when guy asked if i remembered which way the previous valve was faceing and if i remembered if the red gate valve (know now to be called bypass valve)...

does this error code come on automatically if there is no preasure in system due to leak the prv is fine but the water must be going somewhere thanks for help so far

how do i go about checking the aav is venting

preasure stays ok for about 24 hrs then drops to 0 then error code comes on

hepl needed! have a vallient turbomax had air in 1 rad so vented and topped preasure up as usual all was fine but when got up in morning had no heating checked preasure this had dropped again and an error code was showing f24 had topped up before no probs but now no heating and freezing kids...

whats the best way to drill tap holes on acrylic baths just a normal holesaw or something different is there a template suppopsed to come with it it s a mixer tap any tips greatly appreciated also once taps are done and connected is the whirlpool bath no differnt to fitting ordinary bath...

just had new boiler fitted not sure if this is supposed to occur but everyday at the same time the fan kicks in for 5 minutes or so then cuts off is this normal or do i call worcester engineer out thanks for any help

hi just had another nightmare job trying to secure steel bath not a tight fit 5 " away from back wall what do u guys do to secure steel baths