Jupiter01's latest activity

  • J
    Jupiter01 reacted to endecotp's post in the thread Bath tap issue with Like Like.
    As others have said- fix that. There should be a perfect and long-lasting seal between the tap and the bath.
  • J
    Jupiter01 replied to the thread Bath tap issue.
    What’s a rubber band in this situation?
  • J
    Jupiter01 reacted to Madrab's post in the thread Bath tap issue with Thanks Thanks.
    Cheaper deck mixers are always a challenge, the rubber seal never seems to be thick enough, nor does it seem to cover the entire...
  • J
    Jupiter01 reacted to terryplumb's post in the thread Bath tap issue with Thanks Thanks.
    When using the shower it's very likely that water would ,or could, collect anywhere around the vicinity of the tap ,hence it shouldn't...
  • J
    Jupiter01 replied to the thread Bath tap issue.
    I can slacken the tap nuts and reposition to make sure it’s central and the seal is positioned appropriately. Is there anything that...
  • J
    Jupiter01 reacted to Wayners's post in the thread Door handles with Thanks Thanks.
    You will need some circlip pliers. Buy a new spring and fit. I just found a supplier online after searching.
  • J
    Jupiter01 replied to the thread Bath tap issue.
    Water shouldn’t seep through but it also shouldn’t collect at the base of the tap? Over time, this is probably testing the defense of...
    • IMG_7857.jpeg
  • J
    Jupiter01 reacted to terryplumb's post in the thread Bath tap issue with Thanks Thanks.
    Water shouldn't be able to seep through to under the bath. Sounds like a bad installation of the bath. Also, if the tap is turned off...
  • J
    Jupiter01 posted the thread Bath tap issue in Plumbing and Central Heating.
    I’ve got one of these and it’s not very clear from the picture but the nozzle is flat with the body of the tap. This means that even...
    • IMG_7856.jpeg
  • J
    Jupiter01 replied to the thread Door handles.
    Do they come in different sizes and are they easy to squeeze into place?
  • J
    Jupiter01 reacted to Wayners's post in the thread Door handles with Thanks Thanks.
    I've bought new springs for handles online.
  • J
    Jupiter01 posted the thread Door handles in Wood / Woodwork / Carpentry.
    I replaced two sets of these door handles today. They were loose and just dropping down as opposed to springing back to the top...
    • IMG_7840.jpeg
    • IMG_7838.jpeg
  • J
    Jupiter01 posted the thread Gap in window closing in Windows and Doors.
    This tilt and turn window has a gap in the bottom right of the window. This is the hinge end and pictured from the outside. Can I fix...
    • IMG_7848.jpeg
  • J
    Jupiter01 posted the thread Leak in roof lantern in Windows and Doors.
    I’ve had one of these in place for 10 years It was dripping inside along this rafter (marked in red): I had a look at the rubber...
    • IMG_7841.jpeg
    • IMG_7841.jpeg
    • IMG_7843.jpeg
    • IMG_7846.jpeg
  • J
    Jupiter01 reacted to big-all's post in the thread Unseen sides of shed with Thanks Thanks.
    10mm cladding +15mm batton so 25 to 30mm?? but fully a guess delamination off the osb in the areas the nails go through /into is my...
Show older items
Back
Top