Recent content by kez1

You could find out what the exact composition of the metal is from Grant, likely a form of stainless, and ask someone to weld a stainless patch over it for you. As long as it's a good weld, using stainless wire, it should be good to go. Just ideas to try and help you get it moving

I really appreciate the reply, which is straight forward and to the point. I used to repair highly complex high kV and noxious gas equipment when working in the industrial lab as a scientist. So all I was looking for here was straight forward pointers, exactly as you have given. Why not ask...

Def not ply. It's printed banding that looks like ply. It is a very good look a like. I've tried to get a better picture for some reason can't get much better than that. I suspect it is a bit crumbly, the black bit behind the banding. My idea is, once bone dry, mix some wood glue and pine saw...

I discovered a leaking pipe inside a kitchen cabinet. Unfortunately a bit of damage already done. The edge banding of the MDF has curled away leaving an unsightly gap. Will a warm iron after applying some glue into the gap fix this? How would you fix this.

Thanks for the reply. The next day we discovered it was old heating system poly pipe not connected to anything.

SOLUTION:

Our flowmaster cistern filler identical to this one has a failing closing valve. It's not stopping the mains water flow when the float rises up to the top. Can the valve seal be replaced?

I nicked a plastic central heating pipe with the grinder. I'm surprised its not leaking. Quite deep, actually amazed its not leaking. Is there something, a glue or epoxy I can coat round it that will make it good as new, something like a putty?

The roof is concerete tiles. I have a lot of moss on the north side of the roof where the roof gets less sun. It eventually rolls off and fills the gutters Is there anything I can spray, or put on the roof to reduce or stop the moss build up?

Anyone had any issues with fitting these?

I am re-doing facias and soffits, which means new gutters. Currently fitted are half round gutters but deep egg gutters have been suggested for the new install. No one seems to need the run off capacity of deep egg gutters(?), so why do they exist. Installers seem to recommend "deep flow"...

Have a Garage Flat roof 8m x 7m. Very slight run off on it. I needs replacing. What's the best solution for replacing it?

Thank you. I've usued one of those before but didn't think of it. Probarly because I can feel, just about but not quite reach, chuckies/ stones down there, which I am not sure it would shift. I'll try that if all else fails when the weather improves.

Thank you. Very useful link. I can't quite get my hand down the drain for long enough, in this weather, to try and work figure out the type. It's just too cold. Water sitting in there,quite far down, could be becasue it is a p-trap, or just becasue it sits that high with the blockage...

Does an LPG conversion fix this?