Recent content by kujina

Hi all Location: Combined kitchen/living room (ground floor) Sub-floor: Concrete Area: 6.80m x 3.2m I'm thinking of removing the tiles in a combined kitchen living room and then putting down more concrete (to bring the level back up) and finishing it as smooth as reasonably possible to begin...

So generally the way these florescent electronic ballasts work it that they have to be at their capacity or they don't work?

Thanks for the response, according to the Phillips product range page it says 3-5 lamps which makes things confusing. Product range (HF-E 418 TL-D etc)

I have a Philips Essential HF-E 418 TL-D 4 x 18W electronic ballast which I want to wire to 3 18w tubes and I'm using T8 Push on fixing lampholders like below. I have tried wiring up the ballest with one tube so far and it hasn't worked so I want to make sure I'm doing it right to...

I discovered the pressure equalising valve (Deva brand) has builtin check valves.

I doubt the aerator restricts the flow very much at all the gaps few and large. The warm water came out fine when the leaver was pushed all the way to the left on full warm when I tested it before. Anybody know if I should fit a check valve on the warm feed and at what point, before after the...

The tap is a regular mono mixer as far as I know SN003 Mayfair Series N Freestanding Basin Mixer Tap I believe the hot and cold mix in the tap. I did plumb the tap in to test it (before I got the pressure equalising valve) to test it and the hot didn’t come through very well. The cold feed is...

Hello I've been renovating my bathroom, I've bought a mono mixer tap; the cold water is on mains pressure and the warm is gravity feed so I've bought a pressure equalising valve. Should I also be fitting a check valve? ...Thanks...

Hi Is there a door stoping mechanism that does not involve rubber door stops on the floor or wall? This would be for an internal door.

Thanks for the response. One remaning thing I'd like to confirm is that I don't need a rubber gasket between the pan and the tiles (it will be against one large travertine tile).

I will fit the wall hung toilet pan soon and my question is: as the pan spigot is unglazed and rough on the outside and the straight pan connector fits over this, do I need to add anything else to make a water tight seal?