If you refer to my previous photo you will see that the flow meters (where i attach the tap hose) are at the top, and return vaves are at the bottom, which is where I am attaching the drain hose.
I am off for a Christmas drink now - will post to any relies tomorrow.
I shut down all loops ( Flow meter and pin valve) apart from number one. Waited for a steady flow of water then shut down that loop and opened the second loop and so on.
Today I will flush and refill then get back to you. There is no mixing pump and the manifolds dont have a an air vent. Hot water is supplied by a HeatRea Sadia and is pumped by a water pump. Thanks Johntheo5.
The manifold is a 3 loop Uponor Vario S.
I have just installed 3 new flow meters and Pin return valves.
I flushed and filled each loop one at a time, but the flow meters all show the red disc at zero. The water in the glass tubes all sit at around 2.
The return pipes are 1 x warm 2 x coldish...
Thanks for that but have seen that previously. Thats for balancing the system - I want to flush and fill system for which the lower valve needs to be fully open. When I turn the lower valve nothing happens at the flow meter at all.