Recent content by LazyBoy2

Thanks Daz Ian

Hi Tell Thanks for your reply. The floor has a long and complicated history which resulted in it looking like a ploughed field before the first SLC was applied. The builder who applied the SLC gave me several options and told me the one I chose would be smooth but may not be perfectly flat...

I intend to let the internal stats control the fans, so when the exit temp of the kickspace heaters is above 38deg(?) the fan runs. I have a wiser control system installed, but the kickspace heaters are not controlled, they get heat any time the boiler runs (as in A Bypass Rad).

Hi All. I need to do some additional floor levelling on some shallow dips in a floor that was smoothed with floor levelling compound a couple of years ago. The Floor will be covered with 4mm foam underlay and 10mm laminate when it is flat. There are no damp problems. Existing SLC is in good...

Hi Exedon, Thanks for your reply. If I did fit a second 500 unit, to extract the maximum out of the 15mm feed, should it be connected in series or parallel with the existing 800 unit. The Set point on my boiler is low at 50degC, would that be high enough to run both heaters? Would I be better...

Hi All I have 1 Myson 800 Kickspace heater fitted in my bungalow kitchen on part copper, part plastic 15mm flow and return pipes which run directly to the boiler through the loft. Has any body ever fitted 2 of these heaters onto a supply like that? If so how were they connected to the Flow And...

Hi Yes there was power to the bell box when I tested the tamper circuit and yes the switch when tested works but not the terminals used for the tamper on the bell box. I remember checking each output terminal of the tamper loop against pos and neg supply (with the cores back to the panel...

Thanks for the info. Ian

Hi Can I put any brand of sill on this or do I need to source a Duraflex sill? I think Duraflex is the profile used by Safestyle? Thanks Ian

Hi All I fitted an Aritech AS614 alarm box wired back to a galaxy alarm panel but I could not get rid of an alarm box tamper fault. The cable tests out ok and shorting the tamper cable core pair together in the sounder box gets rid of the fault. If I put an ohmmeter across the microswitch and...

Hi All I have A used Safestyle UPVC Door that that I am going to fit into a new made to measure opening in the side of my garage. The door has an aluminium threshhold bar that sits on the door sill. I need to buy a suitable door sill to fit. Is there a particular brand I should buy or avoid...

OK. Thanks for the info. Ian

Ok. Switched in the negative leg. Never heard the term 'Negative Removed' before. I dont have anything other than really basic info on the AS614 and I cant seem to find anything more comprehensive. So I cant say if it is this type of switching applies to the Tamper circuit. The strobe/siren...

Hi Thanks for the quick reply. I have a battery for the AS614. I am not sure what you mean by negative 'removed' should that be negative return? thanks Ian

Hi All Hoping to get some info on the correct connections for an AS614 Sounder fitted to a Galaxy G2-12 board on an existing system. I am an Electrician although I have never worked on alarms but I have been asked to look at this SAB replacement as a favour. My guess is: Galaxy...