Recent content by leeajsl

going to take it for a run in the morning if its still there will follow the injector route if its still there you been very helpful and shed some light on this problem for me very greatfull for you advice on this mater all the best Lee.

thought that was unlikely...had it back to garage to day as they changed some parts other day new coil was ok for a few miles then misfire back the lad had it back on computer again messed around with the coils swaping them had leads off and in and out but he seemed bafeld come away and it was...

Hi thanks for reply there is no coolent loss so will follow your advice above and try your 1st surgestion do you think the new exhaust could have started this problem in any way?

Hi every one...my rover 25 1.4 54 reg has developed a misfire engine light comes on have tested it on a cheap fault finder and it says "misfire due to low fuel level" its had new plugs coil and filter but still no good! it had a new middle section on the exhaust round about the time of the...

Hello all...i am about to lay a new stair carpet and have done this before but just need a bit of advice which is the best way to do this? i know all the prep but what is better too cut the carpet to size or fold edges over its a very short pile carpet so theres not much room for error>>>help??

this has happend twice when i go to start the car all i get is a clicking sound i took battery off charged it and its started the battery was not fully dead it had about 50 - 60% charge in it would this couse the clicking

thanks again lee

should thi fault have been picked up on its m.o.t

thanks john will be taking it back to garage for them to sort it...all the best lee

Just bought a rover 25 54reg after driving for a bit it starts to sqeaking on the drivers wheel also had a burning smell and gets very hot i got a warranty with the car can anyone tell me what is causing this

Tanks for the advice i will try that i am glad it was only a small area 1.5m2 shouldn't take to long to sort it.

Hi used flexible,waterproof ready mixed floor adhesive used the same stuff on my kitchen floor with no problems. as for prep i cleaned the floor and primed it.

Hi i have just layed some floor tiles onto a solid concrete floor i did this on saturday and i am still waiting for them to dry the room they are in has no heating in it, will they ever dry out?

Pilon

Thanks glasgogas will try that.