I'm looking to add a composite door to provide alternative access to my garage. Is there a minimum height above ground level that's recommended? I would like to have a gap of 80mm, then the cill and door. There is a soak away round the garage already. Are there any potential issues with this?
That's great thanks for your help.
The walls are dot and dab so hopefully I can feed the new cables though the gaps.
I am building a media wall (wooden frame and plasterboard). The electric fire will be fitted in to this.
The electric fire will be inbuilt so it isn't a FCU but an isolation switch.
Diagram attached hopefully it will make things clearer.
Blue - Existing Sockets
Green - New Sockets
Red - Isolation Switch
I am looking to add two double sockets and a FCU (connecting to a single socket).
The double sockets will be used for the TV, digibox etc. The FCU and single socket will be used for an electric fire (2kw)
Is it possible for me to extend the existing ring as described on this article...
I'm looking to replace the lino in my kitchen with wooden parquet flooring.
Can anyone recommend any companies who provide good quality products?
After researching my preference would be engineered rather than laminate. Any thoughts on this?
Thanks for any advice/recommendations
Evening all, I'm looking to wall mount my TV in my 2018 new build. The wall is constructed of light weight block. Can anyone recommend suitable fixings? I would rather over engineer it to put my mind at rest. I have used a range of fixings previously but that was in older houses and to brick...
I am looking to replace the compression fittings of the waste pipe of my double kitchen sink. The house is new build and I keep having issues with them leaking. I would prefer to use solvent weld as I have always found it reliable in the past.
The issue that I am having is finding a suitable...
Hi,
I am looking at adding a door to access my garage from the rear garden. It is a new build property built in 2016. It is a single skin brick wall as the pictures show. I assume a lintel will need installed above the new door. Apart from that is there any other work required to allow this? I...
I’m hoping someone can give me some guidance to wire a double light switch. I was swapping it over and I’ve ended up unable to turn the downstairs hall light off from the upstairs landing switch.
The double light switch is used for the downstairs hall light and an external light. There is a...
The oven is a NEFF B57CR22N0B
The following information is listed for the oven:
Electrical installation This product requires hardwiring to a 16 Amp fuse and should be installed by a qualified installer
Power supply 16 Amp (Requires hardwiring to a dedicated circuit)
Electrical power rating...