Recent content by Mark180

Thanks, that explains why I can't get it to work then, looks like I need the Impaq E like the one on the shed door.

Not sure if the pic is clear, dip on tamper and alarm are both switched to number 2. 1,3 and 4 switched to off, power is red and black, blue and yellow to EOL.

Hi, I have a Veritas R8 alarm panel and am trying to get a Texecom impaq s vibration detector to work, I have fitted a Texecom vibration detector to the shed door about 4 years ago with no problem (Different model to this one) power light is showing but i'm just getting a open circuit, looks...

Hi, Yes I found some info on tamper faults before I started this thread, unfortunately I reset the alarm before finding the info. This is what needed to be done .............. Veritas tamper light. How do I find out what caused it? The Veritas alarm has 5 possible types of tamper faults. To...

Thanks, have got 2 keypads connected, just took the covers off both of them to check the springs, think one of them might be the cause, have now refitted and will wait to see what happens, if it does it again I will link out the bell box. Thank you.

Thanks for the reply, keypad tamper is not used, not 100% sure how to link out the bell box, can you advise the 2 contacts I need to bridge. Edit... keypad tamper is connected, just took the cover off and it activated the sounder.

About every 2 - 3 months alarm goes off with tamper fault, tamper in the panel is not connected at all (Just bridged), tried a brand new battery but that's not done the job, is this looking like the fault lies with the bell box ??, have also checked that the tamper spring on the panel sits OK.

Alarm went off this morning early hours, the zone was for the shed / summer house, done a test between the panel and the shed / summerhouse and there is a break in the cable between the two, don't really want to replace with 6 core alarm cable in case it happens again (Installed this run approx...