Recent content by mivy2006

cut it out and use a compression, it likely the self tap aint bored right through

edited coz no1 now being rude haha it says on the tin it fine, I not heard of any problems in my use, but stand corrected if im wrong. :?

i work for the utility company which will perform this piece of work.. I not national grid they only cover the meters... Anyway for alters it on a per m rate... you get two rates, pre-ex and all inc it will be cheaper if you dig... different utility companies operate different charging but...

there nothing wrong with expanding foam around plastic pipes in my opinion

if you did have the isolation valve open when you tested it (as mentioned above) the thermostatic valve on the mixer tap could be shot.

Having bit of a nightmare, existing external water service is in lead... it burst underground somewhere and i need to relay the supply.. Water board said they will do connection in road but i need to do the works on private. Anyway there a boundary retaining wall, i want to come up the face of...

Hi everyone, was wondering if you can help me….. I got a Renault Kangoo 1.5 TDI 2002 plate….. Had fault code (was the sign for the coils warming up, with like a zig-zag above it) come up whilst driving… Next day wouldn’t start, one got going, was fine, until went cold, then same again… Changed...

my impact is a 18v dewault (love it) i use these http://www.ebay.co.uk/itm/MAKITA-P-49965-25pc-SCREWDRIVER-Bit-Set-MAGNETIC-HOLDER-/150467946969?pt=UK_Home_Garden_PowerTools_SM&hash=item230896a9d9#ht_2490wt_750 seem to last great[/url]

Or drill straight through and use nuts n bolts

if you put a compression waste together correctly and tighten, it not gonna leak on a waste pipe, trust me

no point over spending on pressure gauge, it simple kit, just buy cheaper one... I agree you can get allot of kit cheap and tidy i.e screw drivers, pliers, mats, but get what you pay for with slicers, power tools and blow torch.

Eek. Lets hope it tbe trv then

Yeah you need to clip then reg under floor or u get the hammer, it what causes it most in my experience

id guess pipes not clipped

each light will be rated different and clearly state where it can be sited based on IP rating.. so just check with manufactures instructions on your chosen product... If buying on internet, you could ask tech supprt.