Search results

cut it out and use a compression, it likely the self tap aint bored right through

edited coz no1 now being rude haha it says on the tin it fine, I not heard of any problems in my use, but stand corrected if im wrong. :?

i work for the utility company which will perform this piece of work.. I not national grid they only cover the meters... Anyway for alters it on a per m rate... you get two rates, pre-ex and all inc it will be cheaper if you dig... different utility companies operate different charging but...

there nothing wrong with expanding foam around plastic pipes in my opinion

if you did have the isolation valve open when you tested it (as mentioned above) the thermostatic valve on the mixer tap could be shot.

Having bit of a nightmare, existing external water service is in lead... it burst underground somewhere and i need to relay the supply.. Water board said they will do connection in road but i need to do the works on private. Anyway there a boundary retaining wall, i want to come up the face of...

Hi everyone, was wondering if you can help me….. I got a Renault Kangoo 1.5 TDI 2002 plate….. Had fault code (was the sign for the coils warming up, with like a zig-zag above it) come up whilst driving… Next day wouldn’t start, one got going, was fine, until went cold, then same again… Changed...

my impact is a 18v dewault (love it) i use these http://www.ebay.co.uk/itm/MAKITA-P-49965-25pc-SCREWDRIVER-Bit-Set-MAGNETIC-HOLDER-/150467946969?pt=UK_Home_Garden_PowerTools_SM&hash=item230896a9d9#ht_2490wt_750 seem to last great[/url]

Or drill straight through and use nuts n bolts

if you put a compression waste together correctly and tighten, it not gonna leak on a waste pipe, trust me

no point over spending on pressure gauge, it simple kit, just buy cheaper one... I agree you can get allot of kit cheap and tidy i.e screw drivers, pliers, mats, but get what you pay for with slicers, power tools and blow torch.

Eek. Lets hope it tbe trv then

Yeah you need to clip then reg under floor or u get the hammer, it what causes it most in my experience

id guess pipes not clipped

each light will be rated different and clearly state where it can be sited based on IP rating.. so just check with manufactures instructions on your chosen product... If buying on internet, you could ask tech supprt.

Put a pump on it

fitted one to my valiant today, i love it, full brass body, easy fit, 20 yr warranted, nice nice.... Fitted after reading reviews and seems pop opinion that they more reliable than magnatech

£650 a good price, dont forget he will prob have two of them on job so that split... Power flush ideally, but if you do be aware that once system clean, old rads might show holes, they might look nice on the painted surface, but could be rotting underneath (seen this happen alot after a...

my guess, Sounds like thermal cut out devise (OH Thermocoupler) ...baxi will have the boiler under warranty for 1st yr min, so it likely the company who fitted it, will contact baxi (baxi/main) to fix...call them out...

As mentioned above, if you have over tightened this will cause the leak, the olive will be crushed if you have done this as a result... remove olives with pref olive puller if you have one, or very carefully with hacksaw (dont damage pipe, if you do damage pipe cut of damaged section) and use...