Recent content by mjtefc9

Not sure if this is the right section to post this, but I have a white shower tray that is scuffed up. I’m going to wet and dry sand and polish it. But I want to paint it black.. can anyone give any recommendations?? TIA Mark

None, it’s a new build.. and the window is open most of the time

Hi all, I'm painting a small En-suite that is currently covered in silk. Missus wants is matt, so stupidly I bought Crown Vinyl Matt for the feature wall, and White for the rest. Will this work ? I am going to give everything a sand 1st so it adheres to the walls.. If not could I do the...

Thanks both. How do I isolate the one radiator to do these works, as I will need to remove the thermostat. I was looking at draining the whole system, but I don’t have a train off tap on any downstairs rads.

Hi all, How do I take off a currently installed chrome rad and replace with black ? I will obviously also be replacing the TRV valve. It’s 1200x500.. if I buy another will the brackets be able to replace the current bracket positions, as 2 are in tiles. Thanks all!! Never done any...

I might regards the shower tray.. I think I could do the rest ?

Morning all, Other half wants the En Suite shower, tray and screen ripped out and replacing with a back finish. Also wants the grout replacing.. I've bever done anything like this before, any advice? I'm worried about ripping out the tray and not getting the new one in properly ! I'm...

Hi All, Wondering if I could ask advice from the experts. Her indoors wants the house painting again, but I refuse to use gloss anymore. I was told to just lightly sand the glossed areas and paint over with Acrylic egg shell.. and this sounds like a much better idea! Issue is our walls...

Hi all, My workshop/shed framing is only 47x27mm so I want to add some more timber to step it out so it can be easily boarded. Can I use untreated?

Yeah but there is now a Lip of 3mm.. think I'll take all the screws out and try again with a pilot hole

On a plastic base which sits on pavers

Hi all, Got a new Tiger Shed Workshop and I'm really pleased with the quality, however the floor panels butt up against each other and the instructions tell you to put it together via an angled fixing. I've found it raised one side by about 3mm.. Any idea how to fix it ? In hindsight, I...

There are a few sizes needed 25mm, 65mm and some are 40mm

Speed I suppose, also strength.. I only planned on using them in the frame.

Thank you. They actually come in prebuilt panels.. the studs are 44x27mm. They provide nails, but I wanted to screw it all together.