Recent content by Mr_Matty

Anyone??

Bump. Anyone any ideas, please?

Hello All, Just got round to fitting this today and all seemed to be going smoothly, but my central heating just won't come on I clipped in the new receiver unit to the front panel of the bolier, removed all the old wires that were there for the seperate wired receiver and thermostat, and...

Hello All, I have a Worcester Greenstar 28i Junior which is currently linked to a wired room thermostat and external programmer (Lifestyle Model LP711). I have just purchased the DT20RF Programmer as a replacement for the above mentioned set up, and while it seems relatively simple to fit...

Hello bengasman, Not entirely sure, but I believe there's only one heat exchanger on this model. If there is two, how would I go about getting it cleaned? One other thing to note is that house was empty for a number of months prior to me buying it, which could be the cause of the issues...

Thanks for the response, bengasman. Are you referring to ChrisR's post named "2) REPRESSURISING THE PRESSURE VESSEL"? If so, I will follow thoise instructions. Is this likely to resolve the heat problem as well? Thanks, Mr Matty

Hello All, I have recently moved and my new property has the above-mentioned combi boiler fitted. I have two issues with it: 1) If I have my central heating on, hot water is intermittent. I tried running a bath this morning and gave it up as a bad job - the water just wasn't warm...

Thanks for responding. For the past couple of weeks, the programmer doesn't seem to be getting enough power (the hot water LED on it flicks off and on randomly/is very faint, and you can hear the bolier firing up and down accordingly). This morning was the last straw, as I had no hot water...

Hello D_Hailsham, Indeed, that was always my intention. Do you, or anyone else, know whether there'd be any complications if I replaced my faulty one with the ChannelPlus H21 XL? www.inspiredheating.co.uk have the best price from my initial search, but if there are other sites out there...

Hello All, I have a Horstmann ChannelPlus H121 Programmer which has started to play up (it doesn't seem to be able to cope with having Heating and Hot Water switched on at the same time). Can anyone offer a reasonably cheap replacement for this unit, please? Any guidance most welcome...

Thanks SecuritySupplies - that's sorted it. Matty

Hello All, I have recently moved in to a new house that is fitted with an Accenta 6 alarm. I was advised by the previous owner that the battery for the alarm needs replacing, so I have just purchased a replacement. What I would like to know, is how do I now reset the alarm once the new...

Thanks for your help, Dave. As you suspected, I turned up the cylinder 'stat and the radiators got hot again. So it's a new one of these I need then?: http://www.heatingcontrolsonline.co.uk/potterton-myson-act322-actuator-mpe322-msv322-mpe328-msv328-p-122.html Cheers, Matty

Thanks for your respones. I have done as gas4you suggested and linked the red and yellow wires on the 'stat, which, I assume, circumvents it. After switching the power back on, the heating came on for half an hour or so, but then the boiler seemingly stopped heating water (only the pilot...

Hello All, I have a situation where the radiators in my house are turning off before they have warmed the house to the desired temperature. They tend to come on for a while, then turn off, perhaps for an hour or so, before coming back on again. I believe the problem is a defective room...