Recent content by muirgord

Thanks. I have borrowed a daimond saw, but i wasn't sure how it was going to work with thin pieces of tile. Are you saying the tile will behave in the same way as if i cut through the middle of it? I was concerned that it may chip away?

Hi I have a shelf that is not completely level which means the vertical tile to go on the wall needs a very thin piece of the tile removed (4mms at most) I'm assuming if i use the tile cutter (circular saw) that it won't work? Therefore, is it an option to sand away this small section...

Thanks for the advice. The detector i've got doesn't actually connect to anything. You just hold it near and it beeps if it detects a live current. Are you suggesting i get a detector that i can hook up to the wires? Is there any other basic things i could check before doing that? Thanks...

I've got a standard lighting cable running from the ceiling which was functioning as normal. However, now the light is not functioning. I can detect a live signal via a live wire detector and it seems fine but there's still no light. I've replaced the bulb but again no light. The switch also...

Not a thing. When i flick the switch nothing happens. Thought it may be the bulbs that have blown, but when replacing with new bulbs, not a sausage. Any ideas?

Hi I've been fitting 5 downlights in the living room off of the main lighting circuit. When i wired it up first time round it worked perfectly, then when i took the unit down to paint and placed it back up again the lights came on momentairly and now will no longer come on at all. So after...