Recent content by nisafourar

Thank you bernardgreen. The 47k resistor will be used with a surface magnetic contact and all this will be connected to the aux input of a wirelless magnetic contact (MC-302E PG2). This MC-302E obtains power from an on-board 3 V Lithium battery (Low Battery Threshold 2.2 V). I don't know if...

I don't think that i really need a magnetic contact for the internal door but i want to know if something like this could be done. Propably i'll install the MC-302E PG2 with one surface magnetic contact to the exterior door and if i can i'll put a 4.7k resistor (how many Watts shoud be ? ) for...

Thank you very much SimonH2. So if i undesrtand correctly the following will happen. Operation of two doors In series wiring 1st Door Closed - Magnetic contact CLOSED - NO ALARM 2st Door Closed - Magnetic contact CLOSED - NO ALARM No need for resistor In series wiring 1st/2nd Door...

Hello, i would like to use two magnetic contacts connected to the auxilliary input and i want to operate them seperataly.I don't know if this is possible. Thank you for your interest.

Hello, i want to connect two N.C magnetic contacts using parallel wiring in the auxilliary input of the Visonic MC-302E PG2?. From the manual of the MC-302E PG2: a.If the auxiliary input of the MCT-302E PG2 is defined as a Normally Closed (N.C.) type, series connected N.C. sensor contacts...

Thank you again very much , i'll do just that.

Thank you very much.Just wondering my home's main fuse box has already fuses of 10A (except 2 of 16A for kithen) so every socket comes protected by this 10A fuse. I think that i'll just put a 3 amp fuse on the cable and then a plug and from that i suppose that i can connect to every socket in...

Hello again! if i want the PowerMaster 10 panel to be easily moveable/hidden around the house can i use just a plug to connect to AC POWER? or i have to use an unswiched spur. If i use a plug should i install on the cable a fuse or it is not necessary. Thank you very much.

Hello, is there any way that a PGM output (Vmax=30V,Imax=100mAh) can trigger a second alarm panel (same or different) in a different (but nearby) house? I am thinking that this is the best way for two houses a bit far from town but one next to another. What things should be considered? Any...

Hello again, so if i understand correctly the MC-302E PG2 could be installed upside down or in another way. I have some doors that open to the left and i think this is the only way or i have to install it in the wall and from the auxilliary input connect some surface magnetic contacts or just...

I'll buy a Visonic PowerMaster10/30. Just trying to figure out how i can connect the two auxiliary inputs of the Visonic MC-302E PG2 with an OPTEX BX-80NR (same battery operated both) in the first case and second connect the same type transmitter to a KNIGHT YEND21 magnetic contact with 4...

How can I connect two alarm inputs with a detector or magnetic contact using 47ΚΩ resistor for E.O.L wiring? The detector has TAMPER (NC,COM,NO) and ALARM (NC,COM,NO) and the magnetic contact 4 inputs (2 TAMPER and 2 ALARM) Thank you very much.

Hello , i think i found an outdoor detector. It's the OPTEX BX -80NR . So i am wondering if the MC-302E PG2 could be installed inside the BX-80NR. I think that the size would not be a problem. I want this kind of detection in my balkony (12x2,4)m instead of the 90 degrees cover pattern of the...