Recent content by nong

Cheers

Hi I would like to attach and program an LED to illuminate on the 64W when it is armed. It seems I can wire the LED to the Digicom outputs 1 - 8 . Forgive the silly question but where would I connect the ground? Would it be the "DC -" connection on the same connection block as the outputs ...

Thanks , I didn't know that bit about part sets and e/e

If I come downstairs and forget to unset I will probably set it of when I walk past the PIRs (set to "guard") . If they were set to start an entry tone would that be counterproductive? Thanks

Dear Texperts Does anyone know if it's possible to show the alarm status on the panel display? This would be really helpful for me as when i come downstairs in the morning i would know if the panel was set, so as not to forget to unset it. I would like to wire a red LED to an output and have...

I will try this, it's a shame it's so convoluted the process of getting the app up and running Thanks for your help

Hi After installing the smartconnect device to my elite 48w panel ( that was a test of endurance ) I put the panel generated code into the smartconnect app. I now need to register with an installer i'd from the texecom cloud website. When I go there I can't access my dashboard and it says I...

I think l will change it to a door switch instead rather than a pir and troubleshoot, Thanks for the info

I'm not sure what you mean to be honest but I can only say it is in the entrance point and set as exit 1 with a timed arming mode which may be the issue No other devices in the entry/exit point, maybe I should use a door contact instead? Thanks

Hi DIY install (i know) I have a PIR that is sometimes detected on the walk test and sometimes not and it never seems to activate when the alarm is armed. Can I delete this zone and relearn it or do i need to do them all again ? Do I need to put the jumper to commission mode again to do...

Thanks again sorted it, just had to put the commission pin out of commission mode. Thanks for your kind help

Thanks so much, that did the trick, I just need to get rid of the "Exp 1,1 Tamper" now then hopefully it will arm

I'm not sure to be honest as i never programmed them, they just show as tamper when i first powered the system

Thanks , i've tried omitting the zones in zone programming but they still show up as tamper in system alerts ? Thanks

Wireless devices