Recent content by PhotographyJosh

thanks for the suggestions guys, this has been on hold for a few weeks as you can see, coming up to a week off work I can spend more time poking and prodding the innards of this thing :LOL::LOL: really appreciate the replies, didn't even cross my mind about the bridge rectifier! JJ

Hi, I have a Behringer FCA610 that is making a humming noise and flashing the lights when you power it up, I have taken the front board off and it is still humming, I was wondering if anyone has experienced this before? I am suspecting the transformer on the PCB or possibly a cap thats failed...

After testing the circuit I found that the DC rail was fluctuating rapidly between 5.11v and 6.72v after keypad 0 and before rio 2, replaced the cable and the system is back online and working as it was before. Regards Josh

I have recently had to replace the AUX fuse so I was thinking power too (kind of hoping it is so I dont have a panel throwing a fit!) I'll test it tomorrow and post the results. on a side note would it be worth changing the RIO to a power RIO to alleviate these issues in the future? and with a...

Hi, I have a g2-20 panel installed and working fine until 2 nights ago, at about 4pm (14/11) 2 panic buttons leds started flickering red as if they had been pressed and the mk7 by the door has no display but the green led at the bottom is on, the panel is not in an alarm state or reporting any...

3 years, due for replacement may 2019...

I'll have a double check tomorrow, and possibly replace the wire to the keyprox and hope it sorts it, Thanks again Josh

It was about 12.8v, its worked for years and all of a sudden it wont respond... I also have the EOL resistor here too Josh

Hi, I'm having a problem with one of my keyprox modules (address 1), when I went out earlier on I used it to full set via pin number, when I came home again it wouldn't respond to a fob to unset or accept a pin, subsequently the alarm triggered and had to be unset from a second keypad (address...

Oh, bugger... rookie mistake. Thanks Galaxy guy :)

Hi all, I recently posted a question asking about a 24h contact with override key switch (http://tinyurl.com/jdtyw6f) I have installed the zone with the key switch to shunt the contact with so the gate can be opened without the alarm activating, however I am now getting an open signal from the...

Might have to have a look into mitel on sip... I've looked on asterisk's forum to no avail... I'll let you know how it works out, The asterisk system is quite good, I have it running on an Rpi and it works great, the only issue I have is my TFTP server Josh

Hi Carlos74, I've tried that, it seems the problem I'm having is I need to disable the extended licence requirement. How well do Mitel's 5224's play with Asterisk on SIP? how easy are they to convert to SIP? Josh

Hi, Hope someone can help, I recently bought an Avaya 1140e running SIP04.04.14.00 and need to downgrade it to SIP1140e02.02.21.00 so it can register on my PBX system, I can get it to communicate through the TFTP server and it takes the .cfg file but it wont take the .bin file and update, does...