Recent content by sarjo

Oooh good luck when you start! We did not have to use board because we had the existing chimney place that before the gas fire we removed housed an open fire. The first part of our installation involved the widening of the fireplace, new lintel fitted then scratch coated. We were hoping...

I have had a part installation in preparation for the fitting of a multi fuel stove. The installer has let me down and I now need to finish off the job. At the moment there is a 6" chimney liner with a cowling fitted at the roof. At the bottom of the liner there is a solid reducer piece (6"...

Thanks, I am now thinking then - drop a t&e down to the new gang of the switch and wire this cable into the same junction box I am using to feed the supply to the lights thus interrupting the live. The cable at the switch will be brown to comm and blue to L1?

I have a two gang (both one way) lightswitch in my lounge/diner, one for each end of my room. I am fitting a new fireplace and want to put a couple of feature lights above it so am thinking a third gang to switch these on/off independently of the others. Not being a pro but being semi able...

I have recently removed my old radiator and replaced this space with french doors. The only place I can now put a radiator is on a stud wall. The radiator I have is 1600x600 (with only two brackets) and really heavy so am worried that this is too heavy for the wall. Is this radiator too...