Hi All
My airing cuboard is built on to landing above bulk head of my stairs
it houses at minute a 114l cylinder which as been there 20yrs or more .
the raised floor in there which is raised due to being the bulk of the stairs is showing signs of bowing .
next week am due to have my heating...
i'd say around 20yrs old . Would you reckomend changing the lot ? might be just a quick since i will be moving alarm panel to house a larger cylinder in airing cuboard . For a basic system with 2 remote pads 1 up 1 down , 1 bell box and 6 pir's what system would you go for ?
I need to upgrade/change my alarm panel and remote keypads as all buttons are sticking . will my old pir,s and bell box connect to my new panel ? i got a old pyronix system in at minute
http://cgi.ebay.co.uk/KEWTECH-KT62-DIGITAL-LOOP-PSC-RCD-INS-CONT-TESTER-NEW_W0QQitemZ190091279130QQihZ009QQcategoryZ121877QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
thinking of buying that to get me registered with niceic how much u reckon it will go for?
would this be done in the normal way as you do at main incoming supply i.e would you remove the incoming earth feed to the db ?
and whille your on could to tell me the formular for calculating PFC at a db?
When filling out a EIC i always use a seprate SCHEDULE OF TEST RESULTS for any submains feeding seprate CU.
but what should i put for Ze and PFC at the top ?
Hi mate i did the EAL domestic installers course a few months ago i did'nt really learn anything i didn't already know you will be much better off doing 2381 and the 2391 and skip the DIS course altogther