Hi
Firstly, yes you should always use inserts. Even if you are going into a plastic push fit connection.
It is advisable to use the pipe manufacturers inserts but I believe any insert is better than none?? This stops the pipe from being squeezed and poss become out of shape and leak. Can...
I have come across two banging problems on these.
1. resonating external bypass valve. Obviously this would not happen if the heating was off.
The other one, which alot of people are mentioning was the expansion vessel but not the usual problem!!! I have come across this on two seperate...
You never made it very clear. Do you have heating?
Dependant on your answer? it could be you diverter valve?
What is the name of the programmer you have? it may need reseting?
Looking at your picture, you already have a link in LR LS. Therefore your thermostat would not have been working????????????
Take out the link and replace with your two wires
Good luck
Hi.
Normally the filling loop is between the cold water inlet and the ch return but if have come across them on the flow.
The filling loop will have two valves connected to the filling hose. one of them should be a non return valve. This will normally be slightly longer than the normal...
Had a similar problem at a customers house: It turned out to be an easy solution. I opened the stop cock a bit more.
The tank was emptying faster than it filled therefore there was not a good head of water in the tank???
Hope yours is as easy.