Thank You I will look in the morning making sure that none of the wiring is touching metal. I will also make sure that rubber grommets are all in the right place.
I will start around the brake and clutch pedals as I have a feeling that area could be a common place wiring could touch metal.
I have a Renault Modus 1.5dci. The 10a fuse which controls the interior lights keeps blowing (This fuse is also for the electric mirrors and also the cruise control).
I have disconnected all of these things and connected them all back up 1 by 1 and it works for a day and then blows. Because...
I have a Ideal Heat Only Boiler (installed 1989).
open vented system
well maintained
hot water works but heating doesn't.
This happened once before and it turned out to be a relay in timer.
Can you please give me a few hints about what it could be. Thank You
33 People have looked at my post but it seems to be a difficult one as nobody has replied.
I thought I would give a few details.
Potterton Boiler
Now I do know that my gran moans about her heating timer. She says that it clicks loudly whilst on. I presume there is a relay fault or...
Also, can powerflushing machines be hired?
I can only reply to the bottom bit.
Yes Powerflush machines can be hired. HSS do them I think it will be about £60 tops.
Hello
I have just replaced my Grans room Thermostat. It works fine apart from the fact that it keeps clicking every 10 seconds or so. Sometimes the clicking is even more regular.
I am thinking about taking the stat back to the shop but I first want to make sure it is not just me.
I have...
I am not saying that you are definetley wrong but in my experience I have found the immersion to be cheaper. For example this time last year my combined gas and electric was £120. Since I have been using the immersion heater my gas and electric is now £45 per month and has been since August. I...
Fused spur? I am not sure but I do know that there is a immersion heater.
Number of wires coming from boiler = 3. I have just opened up the small box at the base of my boiler with the boiler thermostat on.
Ideal Classic rs40 (I think this was put in when the house was built - about 21 years old)
Upstairs there is the cylinder, pump, cylinder thermostat and small junction box.
The main power supply I think is in the kitchen with the boiler as this is where the fuse switch is. Also the...
I have been told that when my boiler is changed that a new cable will need to be run from the pump (based upstairs in the airing cupboard) to the boiler. I imagine that this means carpet coming up, floor boards coming up.
As I am not fixed on one brand of boiler I thought that to save that...
Please can you tell me which Good boilers do not require a live feed between the boiler and the pump.
I only know of one so far which is the Glowworm flexicom.
By the way it will be a 15w or a 18w.
Thank You
Paul
Thanks to both of you.
My boiler is only 2 meters from my meter. I do have a gas hob but still feel that 15mm will be fine.
This EcoTEC 415 should be drawing a fraction of any combi.
I have a 21 year old Ideal Classic rs40.
I am just about to replace this boiler with a regular heat only boiler as I use my emersion heater on economy 7 (£45 combined gas and electricity fuel bill per month).
I currently have a 15mm gas pipe from my meter to my boiler. Because of this I...