Recent content by srhawksy

Normally try and wait until flue is up to tempo as per Manus instructions etc.. being honest we're getting pushed for time by the end of the day etc.

Flipping heck! Some have been a pain to get under 100 ppm! Firm I've been subbing to says under 100 is fine but the less the better!

They're offering up to ten year warranties of you're a registered fitter, so they must have some faith. I've fitted loads through the eco scheme and they seem ok.... Although the past few have been a bit high on CO. I'm not an oil expert, would high CO cause sooting eventually?

Jesus. You must be a barrel of laughs!

Very true Dan.

'Qualified' he's done a full time course, which he's paid for and so cannot fail to get his 'qualifications' what's worrying is this guy has G3. . apparently..

That's not a list of real qualifications, that's a list of college based certificates, OCN stands for open college network...

This guy is unreal! I'm sure someone point out the VR66 wasn't needed at somepoint but not wasting my time trawling through. The guy was told and wouldn't listen NOA.

:ROFLMAO::ROFLMAO::ROFLMAO: Fekin eejit!

**** it, chuck a combi in :ROFLMAO:

Ffs! This bloke tried belittling so much when I first came on here! What an absolute joke! Oooo I can't draine a rad oooo black stuff oooooh ooooo.......... Fe kin eejit Steel, do you know he website address? It always gives me a chuckle...

I dunno...... Depends.... :whistle: You get my drift though

I guess any aresol would work no?

I remember Tony saying he likes to use silicone to help seal tap connectors........

Good luck...