Recent content by stender

How though?

I dont get you? The bracket is cast in 1 piece. The nuts and bolts are purely to replace the bearings

Ot much difference circa 32mm hole vs 36mm pole. Pole is 1m

I have a screenprinting vacuum table but it has no arm. The basically has a steel pole on the pack with a bracket attached with bearings that slide along the pole. Now the steel pole i have is too thick to fit the bearing bracket and the bracket is not adjustable. So is it possible to either...

which is the locksheild valve? they both have a white cap and brass valve i can open close using a spanner? odd that all are fully open (6 downstairs and 7 upstairs including 2 towel rails). All are fully open and only about 2 have trvs including the problem rad which we switched the trv as...

I only have trv on a couple of radiators, most are just open and close valves and all open

lot of effort. what will that tell me? it does come on some times without me touching anything

I have one radiator in the house that works intermittently. it's the lowest rad in the house and has the drain plug on it. Today for example the heating is on in the house but this radiator is totally cold as are both pipes either side. We previously changed the try as it was intermittent...

It was blue i removed and blue i added, but it eas off amazon so probably cheap chinese crap. Will try the hot. Thanks

This is what i bought. Its the only ones i found with the right measurements on. I just replaced the cold

So i bought a new cartridge which has stopped the drip BUT the tap now turns outwards to turn off instead of facing forward. Are they adjustable?

Thanks. It drips out the aerator but if i unscrew the shower pipe then it drips from there. Do i need to isolate the water if taking the valve out? I see a small plug on the back of the taps so assume i put a small hex in there to take the top off?

Have a dripping bath shower mixer tap. Have watched 2 videos on repairing. One say use a 12mm hex key, take cartridge out and replace o rings. Other says replace washer on taps. Which is it? Also the cartridge video shows unscrewing the cap of the diverter but mine just seems to spin and doesnt...

Yes and yes. I tried gluing with epoxy but came away. No idea on manufacturer

I need to replace a broken folding shower door hinge and struggling to find a replacement. Any ideas on where i might find one?