Earth wire and one crimp ring terminal- thank you! That's ok, I'll just put a hook in the ceiling and I assume that's ok. The ceiling rose looks good, but it will have to match the antique brass finish of the light fitting and I don't want to spend even more now. Thank you!
Hi all,
I bought a metal second hand light fitting (probably B&Q) and upon closer inspection, it seems the previous owner just cut off the 2nd Earth wire leaving a stubby useless end of wire. Any ideas on how to fix this and what the parts are called? Please see attached photos. No instructions...
That's what I meant, sorry...Two earths in some sleeving. Just to reiterate - rookie level here.
I have a multimeter yes. As you said, they must be old wires if the electrician wasn't fussed about them. :)
Removed a light fitting previously fitted by a qualified electrician. (I'm a rookie who knows the basics). Saw a couple of unidentified wires poking through and pulled them out to take a look. Is it ok to have these tucked up not far behind the wires I will be using for a light fitting? (Two...
The new light fitting was one I put up to replace a previous fitting that was fitted by an electrician. He didn't seem to to comment on wiring issues.
I would say that it was my fault because the Earth appeared to be a little loose. I replaced the old block I used with a wago. That seems to...
Thank you- I have had these bulbs in for months and this is the first time they have glowed since fitting the new light fitting? Is it dangerous? I don't really mind the fact that they are glowing now... I just needed to know if it's indicating a problem with the new light which is only about 3...
Hi, is there anyone who could provide a diagnosis? I have 3 LED lightbulbs in the bathroom light fitting.
Last night all 3 were glowing... the only thing that has changed is that on that same evening I fitted a new light fitting on the landing on the same floor of the house. (LED bulbs in new...
Yep perfect!
Live to switch live and Neutral to neutral. All good! Thank you so much for your help! I'm really really grateful, you've honestly made my day!
Also metal part of light fitting to wire with yellow thread running through showed readings.
Wire in cup showed no readings or beeps no matter what I did.
So,
From L in the bulb holder to the wire with no thread running through = BEEP.
From L to the wire with white thread = no beep.
From L to wire with yellow thread = no beep.
From N to wire with no thread = no beep.
From N to wire with white thread = BEEP.
From N to wire with yellow thread = no...