Recent content by tomsim

Just hoping whoever put the surface bar shower fixing kit hasn't crushed the pipe or put the olive over a scratch

There looks to be a small leak coming from the bar shower fixing kit of this bar shower. I am swapping it, I will have to investigate when I remove the swap and shrouds and maybe put some 3/4 female caps on to test. There is a possibility the bar shower fixing kit may just bite up. But this...

So I swapped the flush valve washer and water still ran into the pan. It isn't the fill valve as this shut off ok and well below the over flow line. Would it be ok to undo bolts split the cistern and fit a new flush valve, fill valve, toilet bolts and donut washer? Thanks

Installing it from this side I need to fix the shower to a piece you wood first then fix this to the uprights in the wall

Thanks this is one I need to swap. So I need to cut out of the plasterboard behind.

Has anyone swapped a concealed shower by gaining access to it through the over side of the plasterboard wall, not the tiles.

It's sort of semi concealed like the ideal ones

Thanks is this toilet likely to have a recess in the pan? Or not if not ideal. Possibly just a 2.inch foam donut then

Picture

Is this an ideal standard toilet has a 2inch Gerbit flush valve. Need to do a cistern rebuild. Just wondering if will be the circular donut washer. Thanks

It's not been nipped before. It's just I have nipped a valve on microbore before where the pipe enters the valve and has made it worse once. Another time it was ok

Would you try nipping this has a small leak. Have nipped before and have been ok and also had ones nipped and make worse.

Thanks is a new build the whole house has them on

I am doing a toilet repair replacing the fill valve, syphon and donut washer and bolts. Would you replace the toilet Flexi connector it's not leaking

Which regards to the white uPVC the tray is a quadrant if this effects that